| Most common failures | No# failures |
|---|
| Brake pipe excessively corroded | 8 |
| Windscreen wiper does not clear the windscreen effectively | 6 |
| Registration plate lamp issues | 6 |
| Headlamp aim out of alignment | 6 |
| Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
| Oil leaking excessively from engine |8.4.1 |a| |i|| | 1 |
| Nearside Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
| Nearside Front Anti-roll bar pin or bush excessively worn D Bush (5.3.4 (a) (i)) | 1 |
| Offside Front Anti-roll bar pin or bush excessively worn D Bush (5.3.4 (a) (i)) | 1 |
| Nearside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
| Offside Front Upper Suspension arm pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Offside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Nearside Front Upper Suspension arm pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Nearside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Offside Rear Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Nearside Rear Upper Suspension arm pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Nearside Rear Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a)) | 1 |
| Exhaust carbon monoxide content at idle exceeds manufacturers specified limits (8.2.1.2 (b)) | 1 |
| Rear Prop shaft bearing excessively worn (6.1.7 (b) (i)) | 1 |
| Emissions unable to be completed (8.2.1.2 (d)) | 1 |
| Offside Rear Upper Suspension arm pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b)) | 1 |
| Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b)) | 1 |
| Nearside Front Lower Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i)) | 1 |
| Offside Front Lower Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i)) | 1 |
| Nearside Rear Service brake excessively binding (1.2.1 (f)) | 1 |
| Offside Rear Body has a projection caused by damage panel/trim missing exposing damaged inner arch trim |6.1.C.1| | 1 |
| Nearside Rear Inner Suspension arm pin or bush excessively worn top suspension arm (5.3.4 (a) (i)) | 1 |
| Trailer electrical socket (13 pin) not operating the trailer lamps as intended side lights (4.10 (c) (i)) | 1 |
| Offside Rear Lower Suspension arm pin or bush excessively worn Hub bush (5.3.4 (a) (i)) | 1 |
| Nearside Rear Upper Suspension arm pin or bush excessively worn inner (5.3.4 (a) (i)) | 1 |
| Offside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Nearside Headlamp light intensity severely reduced (4.1.4 (a)) | 1 |
| Horn not working (7.7 (a)) | 1 |
| Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h)) | 1 |
| Suspension system inoperative (5.3.5 (a)) | 1 |
| Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Front Headlamp levelling device inoperative (4.1.5 (a)) | 1 |
| Bonnet cannot be secured in the closed position o/s front latch (3.1 (b) (i)) | 1 |
| Offside Front Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (rear sill inner wheel arch (6.2.2 (d) (i)) | 1 |
| Drivers view of the road through the swept area of the windscreen materially affected by an obstruction paint writing on screen (3.1 (a) (ii)) | 1 |