Most common failures | No# failures |
---|
Headlamp aim out of alignment | 2 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Brake pipe excessively corroded | 2 |
Upper Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Fuel cap/sealing device does not fasten securely by positive means |7.2.4b| | 1 |
Nearside Front position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Offside Side repeater adversely affected by the operation of another lamp |1.4.A.2h| | 1 |
Upper Steering pivot point has excessive play |2.2.B.1g| | 1 |
Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
Nearside Front Seat belt has a cut which has significantly weakened the webbing |5.2.2a| | 1 |
Offside Side repeater not working |1.4.A.2c| | 1 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f| | 1 |
Exhaust emits an excessive level of metered smoke for a non-turbo charged engine |7.4.B.3b| | 1 |
Offside Rear fog lamp not working |1.3.2b| | 1 |
Centre Upper Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e| | 1 |
Offside Front Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 1 |
Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Offside Stop lamp not working |1.2.1b| | 1 |
Vehicle structure excessively corroded within 30cm of towbar mounting |6.6.6| | 1 |
Hazard warning tell tale not working correctly |1.4.B.1e| | 1 |
Indicator tell tale inoperative |1.4.A.2a| | 1 |
Fuel tank leaking |7.2.3| | 1 |
Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |