| Most common failures | No# failures |
|---|
| Headlamp aim out of alignment | 3 |
| Registration plate lamp issues | 3 |
| Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Nearside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Windscreen wiper does not clear the windscreen effectively | 2 |
| Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Service brake: efficiency below requirements |3.7.C.1a| | 2 |
| Direction indicators not working |1.4.A.2c| | 1 |
| Exhaust emits dense blue smoke at idle |7.4.A.1| | 1 |
| Exhaust emits clearly visible black smoke during acceleration |7.4.A2| | 1 |
| Brake pipe inadequately supported |3.6.B.1| | 1 |
| Offside Rear Brake pipe inadequately supported |3.6.B.1| | 1 |
| Rear brake binding | 1 |
| Nearside Rear Hydraulic brake cylinder leaking hydraulic fluid |3.6.A.1| | 1 |
| Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
| Nearside Front passenger door does not latch securely closed |6.2.B.1a| | 1 |
| Rear passenger door does not latch securely closed |6.2.B.1a| | 1 |
| Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement |7.2.4b| | 1 |
| Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Nearside Outer Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Inner Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Front Seat belt not functioning as intended (7.1.2 (c)) | 1 |
| Windscreen washer not working | 1 |
| Nearside Rear Brake pipe excessively damaged (1.1.11 (c)) | 1 |
| Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength rear cross member (5.3.6 (a) (i)) | 1 |
| Offside Front Brake pipe kinked |3.6.B.2b| | 1 |
| Nearside Headlamp not working on main beam |1.7.5a| | 1 |
| Nearside Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
| Nearside Stop lamp adversely affected by the operation of another lamp |1.2.1f| | 1 |
| Offside Rear reflector missing |1.5.1a| | 1 |
| Nearside Stop lamp excessively damaged so that it is not visible from a reasonable distance |1.2.1d| | 1 |
| Nearside Rear position lamp|s| excessively damaged so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
| Offside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
| Brake pedal anti-slip provision missing |3.3.A.1b| | 1 |
| Nearside Front Upper Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Seat belt damaged sufficient to obstruct correct operation of the belt |5.2.2a| | 1 |
| Offside Seat belt damaged sufficient to obstruct correct operation of the belt |5.2.2a| | 1 |
| Nearside Front Upper Headlamp not working on dipped beam |1.7.5a| | 1 |
| Nearside Front Upper Horn not working |1.6.2a| | 1 |
| Centre Front Upper Windscreen washer control is inaccessible to the driver |8.2.1a| | 1 |
| Centre Front Lower Drag link end seriously misaligned |2.2.C.1b| | 1 |
| Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Front Torque/reaction arm has a deteriorated rubber bush resulting in excessive movement |2.4.G.2| | 1 |
| Offside Front Torque/reaction arm has a deteriorated rubber bush resulting in excessive movement |2.4.G.2| | 1 |
| Nearside Front Direction indicators not working |1.4.A.2c| | 1 |
| Offside Front Direction indicators not working |1.4.A.2c| | 1 |
| Offside Rear Direction indicators not working |1.4.A.2c| | 1 |
| Nearside Rear Direction indicators not working |1.4.A.2c| | 1 |
| Stop lamp not working |1.2.1b| | 1 |
| Nearside Stop lamp not working |1.2.1b| | 1 |
| Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Dipswitch operation does not deflect all main beam headlamps to make them dipped beams |1.7.4b| | 1 |
| Rear Stop lamp not working |1.2.1b| | 1 |
| Intermediate drop arm insecure |2.2.B.1a| | 1 |
| Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Front Ball joint has excessive play |2.2.B.1f| | 1 |
| Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Vehicle structure excessively corroded within 30cm of towbar mounting |6.6.6| | 1 |
| Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Offside Front wheel bearing has excessive play |2.5.A.3c| | 1 |
| Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Front Shock absorber has a serious fluid leak |2.7.3| | 1 |