Most common failures | No# failures |
---|
Exhaust emits an excessive level of metered smoke for a non-turbo charged engine |7.4.B.3b| | 4 |
Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
Offside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Nearside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Rear Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |
Rear brake binding | 1 |
Offside Rear Rear reflector missing |1.5.1a| | 1 |
Offside Front Shock absorber has negligible damping effect |2.7.5| | 1 |
Offside Front Shock absorber has a serious fluid leak |2.7.3| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Windscreen wiper does not clear the windscreen effectively | 1 |
Fuel cap/sealing device mounting flange/sealing method defective |7.2.4c| | 1 |
Nearside Front Lower Shock absorber has an excessively worn bush |2.7.4| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Centre Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Front Steering component mounting prescribed area is excessively corroded |2.2.C.1h| | 1 |
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Front brake application uneven | 1 |
Brakes imbalanced across an axle | 1 |
Parking brake is not capable of being maintained in operation by direct mechanical action only |3.1.2| | 1 |
Parking brake lever has no reserve travel |3.1.6b| | 1 |
Nearside Front Brake pipe inadequately supported |3.6.B.1| | 1 |
Offside Front Brake pipe inadequately supported |3.6.B.1| | 1 |