| Most common failures | No# failures |
|---|
| Offside Headlamp not working on main beam |1.7.5a| | 3 |
| Headlamp aim out of alignment | 2 |
| Exhaust system not adequately supported |7.1.1| | 2 |
| Registration plate lamp issues | 2 |
| Nearside Headlamp not working on main beam |1.7.5a| | 2 |
| Horn not working |1.6.2a| | 2 |
| Brake has no servo assistance |3.3.B.2| | 1 |
| Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Brake performance not tested |3.7.A.1| | 1 |
| Service brake: efficiency below requirements |3.7.C.1a| | 1 |
| Parking brake: efficiency below requirements |3.7.C.1b| | 1 |
| Parking brake: efficiency below requirements |3.7.B.7| | 1 |
| Brakes imbalanced across an axle | 1 |
| Parking brake lever has no reserve travel |3.1.6b| | 1 |
| Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Windscreen wiper does not clear the windscreen effectively | 1 |
| Rear Drive shaft uj which forms part of the suspension has excessive play in a universal joint |2.4.G.4b| | 1 |
| Fuel system component leaking |7.2.3| | 1 |
| Offside engine mounting deteriorated resulting in excessive movement |6.1.D.1a| | 1 |
| Offside Front Brake master cylinder/servo mounting prescribed area is excessively corroded Footwell (1.1.21 (e) (i)) | 1 |
| Offside Front Suspension component mounting prescribed area is inadequately repaired Chassis outer near front spring (5.3.6 (a) (i)) | 1 |
| Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
| Offside Front Headlamp aim not tested (4.1.2 (b)) | 1 |
| Position lamp switch does not illuminate the front and rear position lamps with a single operation (4.2.2 (a)) | 1 |
| Speedometer cannot be illuminated (7.8 (c) (ii)) | 1 |
| Nearside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
| Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
| Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
| Offside Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
| Dipswitch operation does not extinguish all main beam headlamps leaving at least one pair of dipped beam headlamps (4.1.3 (b)) | 1 |
| Headlamp aim not tested (4.1.2 (b)) | 1 |
| Main beam tell-tale not working (4.9.1 (a) (ii)) | 1 |
| Rear fog lamp tell-tale not working (4.9.1 (a) (ii)) | 1 |
| Offside Side repeater not working |1.4.A.2c| | 1 |
| Hazard warning switch faulty |1.4.B.1d| | 1 |
| Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
| Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
| Rear Parking brake is not capable of being maintained in operation by direct mechanical action only |3.1.2| | 1 |
| All position lamps not working |1.1.A.3b| | 1 |
| Nearside Rear Shock absorber has a serious fluid leak |2.7.3| | 1 |
| Nearside Stop lamp not working |1.2.1b| | 1 |
| Offside Stop lamp not working |1.2.1b| | 1 |
| Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f| | 1 |
| Headlamp switch faulty |1.7.1| | 1 |
| Main beam `tell-tale` not working |1.7.4c| | 1 |
| Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |