| Most common failures | No# failures |
|---|
| Headlamp aim out of alignment | 3 |
| Registration plate lamp issues | 3 |
| Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 2 |
| Nearside Headlamp not working on main beam |1.7.5a| | 2 |
| Offside Headlamp insecure |1.7.3| | 2 |
| Service brake is causing the vehicle to swerve to the nearside |3.7.C.2| | 1 |
| Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
| Horn not working |1.6.2a| | 1 |
| Nearside Rear Stop lamp not working |1.2.1b| | 1 |
| Offside Rear Stop lamp not working |1.2.1b| | 1 |
| Brake hose excessively deteriorated | 1 |
| Nearside Stop lamp not working |1.2.1b| | 1 |
| Offside Stop lamp not working |1.2.1b| | 1 |
| Offside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
| Windscreen wiper does not clear the windscreen effectively | 1 |
| Nearside Rear Leaf spring to axle securing nut insecure |2.4.B.7b| | 1 |
| Windscreen wiper not working |3.4 |a|| | 1 |
| Windscreen washer not working | 1 |
| Driver`s view of the road through the swept area of the windscreen materially affected by an obstruction wipers, |3.1 |a| |ii|| | 1 |
| Exhaust system insecure detached at tailpipe, |6.1.2 |a|| | 1 |
| Offside Front Position lamp not working |4.2.1 |a|| | 1 |
| Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis, |5.3.6 |a| |i|| | 1 |
| Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis, |5.3.6 |a| |i|| | 1 |
| Nearside Rear Service brake excessively binding |1.2.1 |f|| | 1 |
| Nearside Rear Service brake excessively fluctuating |1.2.1 |e|| | 1 |
| Brakes imbalanced across an axle | 1 |
| Speedometer clearly inoperative |7.8 |b| |ii|| | 1 |
| Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
| Steering system has excessive free play detected at the steering wheel |steering box fitted| |2.2.A.1a| | 1 |
| Offside Brake master cylinder/servo mounting prescribed area is excessively corroded bulkhead, |3.6.C.3| | 1 |
| Offside Headlamp not working on main beam |1.7.5a| | 1 |
| Offside Front Suspension spring mounting prescribed area is excessively corroded chassis, |2.4.A.3| | 1 |
| Body has a sharp edge caused by corrosion hole in o/s front wing, |6.1.C.1| | 1 |
| Stop lamp not working both, |1.2.1b| | 1 |
| Parking brake lever has no reserve travel |3.1.6b| | 1 |
| Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 1 |
| Service brake: efficiency below requirements |3.7.B.7| | 1 |