Most common failures | No# failures |
---|
Brake pipe excessively corroded | 6 |
Headlamp aim out of alignment | 5 |
Brakes imbalanced across an axle | 3 |
Offside Front Headlamp aim beam image kick up to the offside |1.8| | 3 |
Windscreen wiper does not clear the windscreen effectively | 2 |
Parking brake: efficiency below requirements |3.7.B.7| | 2 |
Service brake: efficiency below requirements |3.7.B.7| | 2 |
Offside Headlamp aim beam image kick up to the offside |1.8| | 2 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 2 |
Nearside Rear Stop lamp not working |1.2.1b| | 2 |
Nearside Front Headlamp not in good working order adversely affecting beam image |1.2.4a| | 2 |
Front Exhaust system not adequately supported |7.1.1| | 2 |
Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
Nearside Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i)) | 1 |
Offside Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i)) | 1 |
Rear parking brake recording little or no effort | 1 |
Nearside Rear Direction indicator incorrect colour |1.4.A.2f| | 1 |
Offside Rear Direction indicator incorrect colour |1.4.A.2f| | 1 |
Offside Front Direction indicator incorrect colour |1.4.A.2f| | 1 |
Nearside Front Direction indicator incorrect colour |1.4.A.2f| | 1 |
Central Seat belt anchorage prescribed area strength or continuity significantly reduced both side inner sill (7.1.1 (a) (i)) | 1 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Central Stop lamp not working |1.2.1b| | 1 |
Offside Stop lamp not working |1.2.1b| | 1 |
Nearside Rear Shock absorber has a serious fluid leak |2.7.3| | 1 |
Offside Rear Shock absorber has a serious fluid leak |2.7.3| | 1 |
Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
Direction indicator incorrect colour |1.4.A.2f| | 1 |
Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
Registration plate issues | 1 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer Sill Corroded (5.3.6 (a) (i)) | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer Sill Corroded (5.3.6 (a) (i)) | 1 |
Nearside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner Sill Corroded (5.3.6 (a) (i)) | 1 |
Nearside Rear Sub-frame rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Offside Rear Sub-frame rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Mechanical brake component has restricted free movement | 1 |
Nearside Front Headlamp aim beam image kick up to the offside |1.8| | 1 |
Offside Side repeater not working |1.4.A.2c| | 1 |
Nearside Front Lower Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
Offside Front Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Offside Front Body has a sharp edge caused by damage |6.1.C.1| | 1 |