MOT History from tests of petrol LADA SAMARAs year 2000

Review the list of common LADA SAMARA failures below or to perform a specific mot history check on your LADA then use our popular KnowYourCar service

mot history

Pass percent:25.00%

(The average a petrol LADA SAMARA year 2000 passes without issue)

Based on:8 MOT Tests

Most common failures	No# failures
Windscreen wiper does not clear the windscreen effectively	4
Nearside Stop lamp not working \|1.2.1b\|	2
Offside Stop lamp not working \|1.2.1b\|	2
Exhaust emissions carbon monoxide content at idle excessive \|7.3.D.4\|	2
Brake pipe excessively corroded	2
Hazard warning switch faulty \|1.4.B.1d\|	1
Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	1
Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement \|7.2.4b\|	1
Hazard warning lamps not flashing in phase, with ignition off \|1.4.B.1f\|	1
Hazard warning lamps not flashing in phase, with ignition on \|1.4.B.1f\|	1
Exhaust has part of the system excessively deteriorated \|7.1.1a\|	1
Offside Rear Rear wheel bearing rough when rotated \|2.6.1\|	1
Rear Stop lamp not working \|1.2.1b\|	1
Offside Side repeater incorrect colour \|1.4.A.2f\|	1
Nearside Side repeater incorrect colour \|1.4.A.2f\|	1
Headlamp aim out of alignment	1
Offside Front constant velocity joint gaiter insecurely mounted to its housing \|2.5.C.1a\|	1
Nearside Front Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	1
Nearside Outer Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	1
Offside Outer Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	1
Offside Inner Rear Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	1
Offside Inner Front Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	1
Offside Rear Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	1
Rear Brake load sensing valve linkage seized \|3.6.E.3\|	1
Offside Rear wheel bearing rough when rotated \|2.6.1\|	1
Offside Rear fog lamp not working \|1.3.2b\|	1
Nearside Front constant velocity joint gaiter split \|2.5.C.1a\|	1
Nearside Front wheel bearing has excessive play \|2.5.A.3c\|	1
Centre Steering rack gaiter split \|2.2.D.2d\|	1
Exhaust emissions carbon monoxide content after 2nd fast idle excessive \|7.3.D.3\|	1

We get to these numbers by trawling through over 1 billion MOT test results since 2004 and crunched the numbers. We remove anything to do with Tyres, as they are model independent and group together common non-model specific issues. We are trying to get to a picture of what models have what issues.

Please note: We take the data from the DVSA. This data is raw and can contain typos and spelling mistakes that garages may have entered while recording a MOT result. Specifically miss-match on names of models and makes. We are constantly cleaning the data so bear with the odd issue.

Got suggestions? We’re improving this section all the time. If you have any suggestions, please let us know.

Most common failures	No# failures
Windscreen wiper does not clear the windscreen effectively	4
Nearside Stop lamp not working \|1.2.1b\|	2
Offside Stop lamp not working \|1.2.1b\|	2
Exhaust emissions carbon monoxide content at idle excessive \|7.3.D.4\|	2
Brake pipe excessively corroded	2
Hazard warning switch faulty \|1.4.B.1d\|	1
Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	1
Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement \|7.2.4b\|	1
Hazard warning lamps not flashing in phase, with ignition off \|1.4.B.1f\|	1
Hazard warning lamps not flashing in phase, with ignition on \|1.4.B.1f\|	1
Exhaust has part of the system excessively deteriorated \|7.1.1a\|	1
Offside Rear Rear wheel bearing rough when rotated \|2.6.1\|	1
Rear Stop lamp not working \|1.2.1b\|	1
Offside Side repeater incorrect colour \|1.4.A.2f\|	1
Nearside Side repeater incorrect colour \|1.4.A.2f\|	1
Headlamp aim out of alignment	1
Offside Front constant velocity joint gaiter insecurely mounted to its housing \|2.5.C.1a\|	1
Nearside Front Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	1
Nearside Outer Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	1
Offside Outer Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	1
Offside Inner Rear Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	1
Offside Inner Front Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	1
Offside Rear Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	1
Rear Brake load sensing valve linkage seized \|3.6.E.3\|	1
Offside Rear wheel bearing rough when rotated \|2.6.1\|	1
Offside Rear fog lamp not working \|1.3.2b\|	1
Nearside Front constant velocity joint gaiter split \|2.5.C.1a\|	1
Nearside Front wheel bearing has excessive play \|2.5.A.3c\|	1
Centre Steering rack gaiter split \|2.2.D.2d\|	1
Exhaust emissions carbon monoxide content after 2nd fast idle excessive \|7.3.D.3\|	1

MOT History from tests of petrol LADA SAMARAs year 2000

Find us on Facebook