Most common failures | No# failures |
---|
Steering headbearing has excessive free play |2.2.2| | 10 |
Headlamp aim out of alignment | 10 |
Front Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 7 |
Drive chain excessively loose |6.2.1d| | 6 |
Front wheel bearings have excessive free play |2.3.5b| | 5 |
Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 4 |
Rear shock absorber has inadequate damping effect. |2.4.A.3b| | 3 |
Headlamp at least one does not illuminate on dipped beam |1.2.2a|i|| | 3 |
Horn not working |1.7.3a| | 3 |
Rear wheel bearings have excessive free play |2.4.A.2c| | 2 |
Headlamp at least one does not illuminate on main beam |1.2.2a|ii|| | 2 |
Rear Roller brake test indicates a binding brake |3.3.A1a| | 2 |
Rear Brake pedal has inadequate reserve travel |3.1.3b| | 2 |
Offside Front Front shock absorber seal failed and leaking oil |2.3.3| | 2 |
Throttle operating incorrectly |6.2.1f| | 1 |
Rear Rear position lamp does not illuminate immediately when it is switched on |1.1.3a| | 1 |
Offside Rear Brake rod insecure disconnected and bent (1.1.15 (c)) | 1 |
Offside Rear Brake clevis joint insecure (1.1.15 (c)) | 1 |
Offside Rear Brake component insecure rear drum locating arm insecure from swing arm causing damage to brake rod linkage and clevis joint. (1.1.21 (c)) | 1 |
Front Lower Steering headbearing has excessive wear or free play (2.2.2 (f) (i)) | 1 |
Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
Stop lamp not working not working from rear pedal control (4.3.1 (a) (ii)) | 1 |
Roller brake test The less effective brake control does not achieve an efficiency of 25% (1.2.2 (a) (i)) | 1 |
Brake pedal has inadequate reserve travel |3.1.3b| | 1 |
Offside Front Direction indicator insecure |1.5.3b| | 1 |
Wheel alignment incorrect which adversely affects the handling |2.5.1| | 1 |
Front position lamp does not illuminate immediately when switched on |1.1.3a| | 1 |
Headlamp aim beam image kick up to the offside |1.6| | 1 |
Steering movement excessively `notchy` with the wheel raised |2.2.1b| | 1 |
Fuel tank leaking |7.2.1a| | 1 |
Riders seat insecure |6.2.1a| | 1 |
Rear position lamp does not illuminate immediately when it is switched on |1.1.3a| | 1 |
Exhaust noise is clearly in excess of that emitted by a similar motor bicycle fitted with a standard silencer in average condition |7.1.2| | 1 |
Offside Front shock absorber seal failed and leaking oil |2.3.3| | 1 |
Exhaust is leaking and excessively noisey |7.1.1b| | 1 |
Front Brake disc|s| friction surface contaminated by oil or grease |3.2.A1k| | 1 |
Stop lamp affected by the operation of another lamp |1.3.2| | 1 |
Floor brake test No brake control achieves an efficiency of 30%. |3.3.C1a| | 1 |
Chain guard insecure |6.2.1c| | 1 |
Offside Front Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 1 |
Nearside Rear Footrest missing |6.2.1a| | 1 |
Front wheel bearings are excessively rough |2.3.5b| | 1 |
Rear Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 1 |
Offside Front Leg shield insecure and likely to impede the steering |2.1.2e| | 1 |
Drive chain sprocket carrier worn to excess |6.2.1e| | 1 |
Wheel alignment incorrect which adversely affects the steering |2.5.1| | 1 |
Front Front position lamp does not illuminate immediately when switched on |1.1.3a| | 1 |
Rear Rear shock absorber has inadequate damping effect. |2.4.A.3b| | 1 |
Fuel cap sealing washer torn |7.2.2c| | 1 |
Stop lamp remains on when the brake is released |1.3.1e| | 1 |
Front Motorcycle structure excessively distorted |6.1.1a| | 1 |
Roller brake test The less effective brake control does not achieve an efficiency of 25%. |3.3.A2b| | 1 |
Nearside Front Direction indicator insecure |1.5.3b| | 1 |
Front Brake back plate|s| securing bolt|s| missing caliper mount |3.2.A1j| | 1 |
Rear Brake locking device missing tie arm |3.2.A1e| | 1 |
Headlamp main beam affected by the operation of another lamp |1.2.2c| | 1 |
Registration plate issues | 1 |
Brake hose damaged | 1 |
Horn not working (7.7 (a) (ii)) | 1 |
Rear Roller brake test indicates a severely grabbing brake |3.3.A1b| | 1 |
Front Stop lamp remains on when the brake is released |1.3.1e| | 1 |
Rear Brake pedal is bent and the brake cannot be readily applied |3.1.3c| | 1 |
Centre Headlamp at least one does not illuminate on dipped beam |1.2.2a|i|| | 1 |
Centre Headlamp at least one does not illuminate on main beam |1.2.2a|ii|| | 1 |
Centre Steering headbearing has excessive free play |2.2.2| | 1 |
Rear Roller brake test indicates a sticking brake |3.3.A1a| | 1 |
Steering headbearing has excessive wear or free play (2.2.2 (f) (i)) | 1 |
Rear Brake pedal is bent and the brake cannot be readily applied (1.1.2 (d)) | 1 |
Front Stop lamp not working (4.3.1 (a) (ii)) | 1 |
Centre Front Steering headbearing has excessive free play |2.2.2| | 1 |
Nearside Front Front shock absorber seal failed and leaking oil |2.3.3| | 1 |
Front Steering headbearing has excessive free play |2.2.2| | 1 |