Most common failures | No# failures |
---|
Headlamp aim out of alignment | 9 |
Front Roller brake test indicates a binding brake |3.3.A1a| | 9 |
Rear Roller brake test indicates a binding brake |3.3.A1a| | 7 |
Throttle operating incorrectly |6.2.1f| | 7 |
Nearside Front shock absorber seal failed and leaking oil |2.3.3| | 6 |
Offside Front shock absorber seal failed and leaking oil |2.3.3| | 6 |
Front Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 6 |
Exhaust is leaking and excessively noisey |7.1.1b| | 5 |
Horn not working |1.7.3a| | 4 |
Registration plate issues | 4 |
Front Roller brake test indicates excessive fluctuation of brake effort |3.3.A1d| | 4 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 4 |
Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 3 |
Front wheel bearings have excessive free play |2.3.5b| | 3 |
Offside Front Footrest insecure |6.2.1a| | 3 |
Offside Front position lamp|s| not working |1.1.A.3b| | 3 |
Steering headbearing has excessive free play |2.2.2| | 2 |
Fuel hose leaking |7.2.1a| | 2 |
Rear position lamp does not illuminate immediately when it is switched on |1.1.3a| | 2 |
Front Front suspension has inadequate damping effect. |2.3.6c| | 2 |
Rear wheel bearings have excessive free play |2.4.A.2c| | 2 |
Front Floor brake test indicates a binding brake |3.3.C2c| | 2 |
Fuel system component leaking |7.2.1a| | 2 |
Offside Front Front shock absorber seal failed and leaking oil |2.3.3| | 2 |
Rear Brake excessively binding |1.2.1 |f|| | 2 |
Front Front wheel bearings have excessive free play |2.3.5b| | 2 |
Rear Roller brake test indicates excessive fluctuation of brake effort |3.3.A1d| | 2 |
Rear Floor brake test indicates a sticking brake |3.3.C2c| | 2 |
Front Hydraulic brake control feels spongy |3.1.4a| | 2 |
Front Brake lever cannot be applied smoothly |3.1.3d| | 2 |
Front suspension has inadequate damping effect. |2.3.6c| | 2 |
Offside Front Direction indicator insecure |1.5.3b| | 2 |
Front An item not tested |Manual| | 2 |
Rear An item not tested |Manual| | 2 |
Registration plate lamp issues | 2 |
Offside Front Shock absorber has a serious fluid leak |5.3.2 |b|| | 1 |
Front Brake disc|s| friction surface contaminated by oil or grease |3.2.A1k| | 1 |
Front Wheel has an excessively distorted bead rim. |4.2.2| | 1 |
Rear Brake disc|s| securing bolt|s| missing |3.2.A1g| | 1 |
Front Headlamp flickers when tapped lightly by hand |1.2.4c| | 1 |
Brake pipe excessively corroded | 1 |
Roller brake test indicates a binding brake |3.3.A1a| | 1 |
Rear shock absorber has inadequate damping effect. |2.4.A.3b| | 1 |
Nearside Fuel system component leaking |7.2.1a| | 1 |
Nearside Front Brake disc|s| excessively worn |3.2.A1l| | 1 |
Offside Front Brake caliper|s| insecure |3.2.A1j| | 1 |
Rear position lamp insecure |1.1.1c| | 1 |
Rear Brake disc|s| cracked |3.2.A1g| | 1 |
Nearside Front Brake disc|s| friction surface contaminated by oil or grease |3.2.A1k| | 1 |
Rear Rear reflector on motorcycle missing |1.4.1| | 1 |
Brake hose leaking fluid |3.2.B4| | 1 |
Rear Hydraulic brake control creeps under load. |3.1.4a| | 1 |
Brake reaction bracket securing bolt|s| loose |3.2.A1j| | 1 |
Front Locking devices not correctly fitted which may make the motor bicycle dangerous to ride |6.2.1h| | 1 |
Front mudguard insecure |2.3.7| | 1 |
Rear suspension has corrosion which reduces the strength of a load bearing member or its supporting structure. |2.4.A.2d| | 1 |
Rear Brake disc|s| excessively pitted |3.2.A1l| | 1 |
Indicator switch does not operate the direction indicators on the side selected |1.5.4| | 1 |
Rear Floor brake test indicates a binding brake |3.3.C2c| | 1 |
Offside Exhaust excessively deteriorated silencer |7.1.1a| | 1 |
Front Roller brake test indicates a severely grabbing brake |3.3.A1b| | 1 |
Centre Rear position lamp does not illuminate immediately when it is switched on |1.1.3a| | 1 |
Hazard warning switch inoperative |4.4.2 |a| |ii|| | 1 |
Stop lamp|s| missing |4.3.1 |a| |ii|| | 1 |
Parking brake efficiency less than 50% of the required value |1.4.2 |a| |ii|| | 1 |
Offside Rear Roller brake test indicates a binding brake |3.3.A1a| | 1 |
Centre Front Roller brake test indicates a binding brake |3.3.A1a| | 1 |
Exhaust excessively deteriorated |7.1.1a| | 1 |
Rear suspension bush has excessive free play |2.4.A2a|i|| | 1 |
Exhaust mounting missing |7.1.1c| | 1 |
Direction indicator not working |1.5.1c| | 1 |
Rear suspension fouling which affects the movement of the rear suspension |2.4.A.3a| | 1 |
Outer Rear Lower Brake disc|s| friction surface contaminated by oil or grease |3.2.A1k| | 1 |
Front Headlamp at least one does not illuminate on dipped beam |1.2.2a|i|| | 1 |
Rear wheel spindle securing nut locking device missing |2.4.A.2b| | 1 |
Headlamp at least one does not illuminate on dipped beam |1.2.2a|i|| | 1 |
Hydraulic brake cylinder locking device missing pedal/master cylinder |3.6.A.2d| | 1 |
Front Brake pedal spongy |3.3.B.1b| | 1 |
Hazard warning switch missing |1.4.B.1d| | 1 |
Front Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Nearside Front shock absorber leaking oil |9.2.7b| | 1 |
Parking brake lever, pawl mechanism pivots or their associated mountings are insecure |3.1.4b| | 1 |
Centre front brake binding |3.7.B.1| | 1 |
Fuel system component leaking |7.2.3| | 1 |
Nearside Rear Trikes, quads or pre-68 vehicles, service brake efficiency below requirements |3.7.B.7| | 1 |
Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition |7.1.4| | 1 |
Floor brake test indicates a sticking brake |3.3.C2c| | 1 |
Rear suspension component excessively corroded. |2.4.A.1a| | 1 |
Sidecar wheel bearings have excessive free play |5.2.3c| | 1 |
Front position lamp does not illuminate immediately when switched on |1.1.3a| | 1 |
Offside Direction indicators not working |1.5.1c| | 1 |
Front Brake excessively binding |1.2.1 |f|| | 1 |
Floor brake test brake efficiency less than 27.5% overall |1.2.2 |a| |ii|| | 1 |
Offside Rear position lamp does not illuminate immediately when it is switched on |1.1.3a| | 1 |
Rear Exhaust excessively deteriorated |7.1.1a| | 1 |
Offside Front Footrest missing |6.2.1a| | 1 |
Nearside Handlebar handgrip not secure to handlebars. |2.1.1c| | 1 |
Front Brake disc|s| excessively worn |3.2.A1l| | 1 |
Front Brake disc|s| has excessive run out |3.2.A1m| | 1 |
Rear Rear mono-shock pivot excessively worn |2.4.B.4| | 1 |
Brake pedal cannot be released smoothly |3.1.3d| | 1 |
Outer Rear Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 1 |
Horn not loud enough to be heard by another road user |1.7.3a| | 1 |
Rear Exhaust is leaking and excessively noisey |7.1.1b| | 1 |
Steering movement excessively `notchy` with the wheel raised |2.2.1b| | 1 |
Floor brake test The less effective brake control does not achieve an efficiency of 25%. |3.3.C1b| | 1 |
Fuel tank leaking |7.2.1a| | 1 |
Rear Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 1 |
Rear Brake pedal has insufficient reserve travel |1.1.2 |a|| | 1 |
Floor brake test The less effective brake control does not achieve an efficiency of 25% |1.2.2 |a| |i|| | 1 |
Nearside Rear IMPORTANT. Do not use failure or PRS against this item. For other Body and Structure component defects please enter 5690 in the `Find item` box above. mud guard insecure |9.6| | 1 |
Nearside IMPORTANT. Do not use failure or PRS against this item. For other Body and Structure component defects please enter 5690 in the `Find item` box above. horn insecure |9.6| | 1 |
Offside Rear reflector missing |1.5.1a| | 1 |
Front Horn not working |1.6.2a| | 1 |
Rear Drive shaft which forms part of the suspension coupling gaiter insecure to the extent that it no longer prevents the ingress of dirt etc |2.4.G.4e| | 1 |
Centre Headlamp aim beam image kick up to the offside |1.8| | 1 |
Nearside Handlebar mounting clamp bolt loose |9.2.1c| | 1 |
Offside Suspension component mounting prescribed area is fractured |2.4.A.3| | 1 |
Offside Rear Upper Motorcycle structure insecure and likely to affect the correct functioning of the steering or braking |6.1.1c| | 1 |
Offside Front Brake disc|s| has excessive run out |3.2.A1m| | 1 |
Rear reflector on motorcycle missing |1.4.1| | 1 |
All position lamps do not illuminate immediately when switched on |1.1.3a| | 1 |
Direction indicators flashing more than 120 times per minute |1.5.1c| | 1 |
Centre Exhaust is leaking and excessively noisey |7.1.1b| | 1 |
Rear Brake disc|s| excessively worn |3.2.A1l| | 1 |
Nearside Front Direction indicator not working |4.4.1 |a| |ii|| | 1 |
Handlebar mounting clamp loose |9.2.1c| | 1 |
Stop lamp not working |1.2.1b| | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Offside Stop lamp not working |1.2.1b| | 1 |
Stop lamp remains on when the brakes are released | 1 |
Centre Rear Lower Rear mono-shock pivot seized |2.4.B.4| | 1 |
Centre Rear Lower Rear mono-shock insecure |2.4.B.4| | 1 |
Rear Roller brake test indicates a severely grabbing brake |3.3.A1b| | 1 |
Front wheel bearings are excessively rough |2.3.5b| | 1 |
Front shock absorber seal failed and leaking oil |2.3.3| | 1 |
Front Stop lamp not working (4.3.1 (a) (ii)) | 1 |
Rear All position lamps not working (4.2.1 (a)) | 1 |
Rear Stop lamp not working (4.3.1 (a) (ii)) | 1 |
Handlebar insecure to the extent that steering is adversely affected (2.2.1 (d) (ii)) | 1 |
Front Throttle operating incorrectly sticking when turning left or right (6.2.7 (a) (i)) | 1 |
Headlamp aim projected beam image obviously incorrect bulb in wrong (4.1.2 (c)) | 1 |
All direction indicators obviously incorrectly positioned all (4.4.3 (a)) | 1 |
Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
Headlamp not working on main beam (4.1.1 (a) (ii)) | 1 |
Front Shock absorber has negligible damping effect No front damping. Dangerous. Do not ride. (5.3.2 (b)) | 1 |