Most common failures | No# failures |
---|
Nearside Stop lamp not working |1.2.1b| | 1 |
Exhaust emissions carbon monoxide content at idle excessive |7.3.D.4| | 1 |
Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 1 |
Exhaust emissions hydrocarbon content after 2nd fast idle excessive |7.3.D.3| | 1 |
Exhaust emissions Lambda reading after 2nd fast idle outside specified limits |7.3.D.3| | 1 |
Nearside Front Body has a sharp edge caused by corrosion wheel arch/wing |6.1.C.1| | 1 |
Offside Front Body has a sharp edge caused by corrosion wheel arch/wing |6.1.C.1| | 1 |
Nearside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Offside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced floor to inner sill (7.1.1 (a) (i)) | 1 |
Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced floor (7.1.1 (a) (i)) | 1 |
Nearside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Headlamp aim not tested |1.8.A.1c| | 1 |
Nearside Front Lower Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Lower Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front Lower Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Offside Front Lower Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Offside Headlamp not working on dipped beam |4.1.1 |a| |ii|| | 1 |
Front Bumper insecure |6.1.4 |a| |i|| | 1 |
Offside Front Lower Suspension component ball joint excessively worn |5.3.4 |a| |i|| | 1 |
Registration plate lamp issues | 1 |
Offside Rear fog lamp not working |1.3.2b| | 1 |
Offside Front Front wheel bearing rough when rotated |2.5.A.2| | 1 |