| Most common failures | No# failures |
|---|
| Registration plate lamp issues | 10 |
| Headlamp aim out of alignment | 3 |
| Supplementary Restraint System warning lamp indicates a fault |5.4.2| | 3 |
| Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 2 |
| Electronic stability control warning lamp indicates a fault (7.12 (e)) | 2 |
| Offside Headlamp not working on main beam |1.7.5a| | 2 |
| Windscreen washer not working | 2 |
| Nearside Front Seat belt retracting mechanism defective |7.1.2 |e|| | 1 |
| Nearside Rear Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt |6.1.7 |g| |ii|| | 1 |
| Electronic stability system warning lamp indicates a fault |3.4.1c| | 1 |
| Nearside rear brake excessively fluctuating |3.7.B.3| | 1 |
| Offside rear brake excessively fluctuating |3.7.B.3| | 1 |
| Offside Front Headlamp not working on main beam |1.7.5a| | 1 |
| Nearside Headlamp aim aimed so that it dazzles other road users |1.8.A.1a| | 1 |
| Nearside Front Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Nearside Rear Direction indicator incorrect colour |4.4.3 |a|| | 1 |
| Offside Rear Direction indicator incorrect colour |4.4.3 |a|| | 1 |
| Offside Headlamp aim projected beam image is obviously incorrect |4.1.2 |c|| | 1 |
| Nearside Front Lower Suspension arm rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Anti-lock braking system warning lamp does not illuminate |3.4.1b| | 1 |
| Anti-lock braking system warning lamp is missing. |3.4.1a| | 1 |
| Nearside Rear Oil leaking excessively from transmission drive shaft oil seal |8.4.1 |a| |i|| | 1 |
| Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
| Rear Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 1 |
| Nearside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Offside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Electronic stability control wheel speed sensor missing (7.12 (a)) | 1 |
| Position lamp not working N/S/F (4.2.1 (a) (ii)) | 1 |
| Windscreen wiper does not clear the windscreen effectively | 1 |
| Supplementary restraint system warning lamp indicates a fault (7.1.6 (a)) | 1 |
| Offside Front Headlamp aim projected beam image is obviously incorrect |4.1.2 |c|| | 1 |
| Nearside Rear Direction indicator incorrect colour (4.4.3 (a)) | 1 |
| Offside Rear Direction indicator incorrect colour (4.4.3 (a)) | 1 |
| Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Fuel cap/sealing device ineffective Temp cap fitted does not form an effective seal. (6.1.3 (b) (i)) | 1 |
| Offside Track rod end ball joint has excessive play (2.1.3 (b) (i)) | 1 |
| Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
| Nearside Headlamp not working on dipped beam Unable to check beam image. (4.1.1 (a) (ii)) | 1 |
| Nearside Rear Service brake excessively binding (1.2.1 (f)) | 1 |
| Nearside Rear Suspension rod ball joint dust cover no longer prevents the ingress of dirt Tie rod (5.3.4 (b) (ii)) | 1 |
| Offside Rear Suspension rod ball joint dust cover no longer prevents the ingress of dirt Tie rod (5.3.4 (b) (ii)) | 1 |
| Nearside Rear Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Offside Rear Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Suspension system inoperative Warning lamp indicates suspension fault. Possibly n/s/f suspension unit (5.3.5 (a)) | 1 |
| Nearside Front Shock absorbers has negligible damping effect (5.3.2 (d)) | 1 |
| Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g)) | 1 |
| Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Rear Rear fog lamp with a multiple light source more than 1/2 not functioning (4.5.1 (a) (ii)) | 1 |
| Main beam tell-tale not working (4.9.1 (a) (ii)) | 1 |
| Headlamp not working on main beam both (4.1.1 (a) (ii)) | 1 |
| Brake pipe excessively corroded | 1 |
| Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
| Position lamp not working O/S/F (4.2.1 (a) (ii)) | 1 |