| Most common failures | No# failures |
|---|
| Nearside Stop lamp not working |1.2.1b| | 3 |
| Parking brake: efficiency below requirements |3.7.B.7| | 2 |
| Nearside rear brake recording little or no effort |3.7.B.5a| | 1 |
| Seat belt anchorage prescribed area is inadequately repaired |5.2.6| | 1 |
| Nearside Front wheel bearing has excessive play |2.5.A.3c| | 1 |
| Brake pipe excessively corroded | 1 |
| Registration plate lamp issues | 1 |
| Headlamp aim out of alignment | 1 |
| Rear Rear position lamp|s| insecure |1.1.A.3a| | 1 |
| Fuel cap/sealing device sealing washer missing |7.2.4c| | 1 |
| Exhaust system not adequately supported |7.1.1| | 1 |
| Offside Front Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
| Nearside Front Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
| Offside Front Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
| Centre Rear Lower Body has a sharp edge caused by damage |6.1.C.1| | 1 |
| Offside Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
| Nearside Front Body or chassis is damaged, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone `A` |8.3.1b| | 1 |
| Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Inner Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Inner Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Inner Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Inner Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |