| Most common failures | No# failures |
|---|
| Windscreen wiper does not clear the windscreen effectively | 3 |
| Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 2 |
| Nearside Front Shock absorbers has a serious fluid leak | 2 |
| Service brake efficiency below requirements (1.2.2 (a) (i)) | 2 |
| Brake performance not tested (1.2.1 (g)) | 2 |
| Nearside Front Upper Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 2 |
| Offside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 2 |
| Parking brake efficiency below requirements (1.4.2 (a) (i)) | 2 |
| Registration plate lamp issues | 2 |
| Offside Front Inner Seat belt anchorage prescribed area strength or continuity significantly reduced Sill (7.1.1 (a) (i)) | 1 |
| Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced Outrigger (7.1.1 (a) (i)) | 1 |
| Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wing under bonnet (5.3.6 (a) (i)) | 1 |
| Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Wing (5.3.6 (a) (i)) | 1 |
| Offside Front Braking system leaking (1.1.3 (d)) | 1 |
| Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i)) | 1 |
| Offside Front Service brake excessively binding (1.2.1 (f)) | 1 |
| Nearside Front Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting (6.2.2 (d) (i)) | 1 |
| Offside Front Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting (6.2.2 (d) (i)) | 1 |
| Brake master cylinder/servo mounting prescribed area is excessively corroded (1.1.21 (e) (i)) | 1 |
| Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 1 |
| Brake load sensing valve linkage defective and function impaired (1.1.17 (a)) | 1 |
| Offside Front Lower Brake master cylinder/servo mounting prescribed area is excessively corroded corrosion by washer bottle (also body mounting area) (1.1.21 (e) (i)) | 1 |
| Rear Brake disc contaminated (1.1.14 (b)) | 1 |
| Rear Parking (secondary brake) on a single line braking system has inadequate effort at a wheel both sides (1.3.1 (a) (i)) | 1 |
| Horn not working (7.7 (a) (ii)) | 1 |
| Nearside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
| Brake hose excessively deteriorated | 1 |
| Nearside Front Lower Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
| Front Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced wheel arch/both sides (6.1.1 (c) (i)) | 1 |
| Brake pipe excessively corroded | 1 |
| Offside Front Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i)) | 1 |
| Headlamp aim out of alignment | 1 |
| Brake master cylinder/servo mounting prescribed area is excessively corroded Hole in bulk head above servo mounting (1.1.21 (e) (i)) | 1 |
| Brakes imbalanced across an axle | 1 |
| Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Nearside Parking brake inoperative on one side (1.4.1 (a)) | 1 |
| Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i)) | 1 |
| Rear Brake pipe leaking on a hydraulic braking system (1.1.11 (b) (ii)) | 1 |
| Rear Brake performance unable to be tested (1.2.1 (g)) | 1 |
| Horn not working (7.7 (a)) | 1 |
| Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced out rigger (7.1.1 (a) (i)) | 1 |
| Offside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i)) | 1 |
| Offside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i)) | 1 |
| Windscreen washer not working | 1 |
| Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i)) | 1 |