Most common failures | No# failures |
---|
Brake pipe excessively corroded | 8 |
Headlamp aim out of alignment | 5 |
Registration plate lamp issues | 5 |
Parking brake: efficiency below requirements |3.7.B.7| | 5 |
Parking brake lever has no reserve travel |3.1.6b| | 3 |
Windscreen wiper does not clear the windscreen effectively | 3 |
Offside Front Direction indicator incorrect colour |1.4.A.2f| | 2 |
Fuel tank insecure |7.2.1| | 2 |
Windscreen wiper blade insecure | 2 |
Brakes imbalanced across an axle | 2 |
Offside Rear Hazard warning tell tale not working correctly |1.4.B.1e| | 1 |
Brake pedal anti-slip provision worn smooth |3.3.A.1b| | 1 |
Rear Rear fog lamp not working |1.3.2b| | 1 |
Offside Front Front suspension has excessive play in a upper suspension ball joint |2.5.B.1a| | 1 |
Offside Front Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Offside Front Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Nearside Indicator tell tale inoperative |1.4.A.2a| | 1 |
Offside Indicator tell tale inoperative |1.4.A.2a| | 1 |
Driver`s seat cannot be secured in the upright position. |6.2.A.2| | 1 |
Offside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
Seat belt locking mechanism does not secure or release |5.2.5a| | 1 |
Offside Front Upper Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
Nearside Front Upper Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
Nearside Front Lower Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
Nearside Front Brake hose twisted |found during steering lock to lock check| |2.2.D.2b| | 1 |
Brake warning device not working correctly |3.3.D.3a| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Nearside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Rear parking brake recording little or no effort | 1 |
Passenger`s airbag obviously defective |5.4.1| | 1 |
Brake master cylinder/servo mounting prescribed area is excessively corroded by washer bottle |3.6.C.3| | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Bonnet retaining device ineffective |8.4.2| | 1 |
Brake load sensing valve has been disconnected and was fitted as standard |3.6.E.2| | 1 |
Rear brake application uneven | 1 |
Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
Registration plate issues | 1 |
Battery insecure and likely to cause a short circuit (4.13 (a) (ii)) | 1 |
Rear Service brake excessively binding N/S and O/S (1.2.1 (f)) | 1 |
Nearside Front Upper Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i)) | 1 |
Nearside Rear Lower Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting middle (6.2.2 (d) (i)) | 1 |
Offside Rear Lower Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i)) | 1 |
Brake load sensing valve seized but ABS functioning (1.1.17 (c) (i)) | 1 |
Front Headlamp not working on dipped beam both (4.1.1 (a) (ii)) | 1 |
Offside Front Headlamp not working on main beam (4.1.1 (a) (ii)) | 1 |
Offside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
Drivers door likely to open inadvertently or not remain closed (6.2.3 (b) (ii)) | 1 |
Fuel cap/sealing device missing (6.1.3 (b) (i)) | 1 |
Front Upper Position lamp not working both (4.2.1 (a) (ii)) | 1 |
Offside Rear Suspension arm pin or bush excessively worn d bush (5.3.4 (a) (i)) | 1 |
Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting chassis near leaf spring area (6.2.2 (d) (i)) | 1 |
Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting chassis near leaf spring area (6.2.2 (d) (i)) | 1 |
Nearside Front Lower Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting near brake servo area (6.2.2 (d) (i)) | 1 |
Offside Rear Stop lamp not working |1.2.1b| | 1 |
Offside Rear position lamp|s| incomplete |1.1.4a| | 1 |
Body insecure and dangerous to other road users |6.1.B.1b| | 1 |
Brake pedal anti-slip provision missing |3.3.A.1b| | 1 |
Nearside All position lamps not working |1.1.A.3b| | 1 |
Nearside Rear All position lamps not working |1.1.A.3b| | 1 |
Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |
Drive shaft uj which forms part of the suspension has excessive play in a universal joint |2.4.G.4b| | 1 |
Nearside Front Body has a sharp edge caused by damage |6.1.C.1| | 1 |
Offside Rear brake disc contaminated by oil |3.5.1h| | 1 |
Offside Front front brake grabbing severely |3.7.A.2b| | 1 |
Nearside Front Direction indicator incorrect colour |1.4.A.2f| | 1 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Body has a projection caused by damage |6.1.C.1| | 1 |
Nearside Rear Anti-roll bar has excessive play in a pin/bush |2.4.G.2| | 1 |
Offside Rear Anti-roll bar has excessive play in a pin/bush |2.4.G.2| | 1 |