Most common failures | No# failures |
---|
Headlamp aim out of alignment | 7 |
Battery insecure |1.9.1| | 3 |
Windscreen wiper does not clear the windscreen effectively | 3 |
Registration plate lamp issues | 2 |
Rear brake binding | 2 |
Brakes imbalanced across an axle | 2 |
Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill area excessive corrosion (7.1.1 (a) (i)) | 1 |
Front Service brake excessively binding nearside and offside (1.2.1 (f)) | 1 |
Stop lamp(s) all not working (4.3.1 (a) (iii)) | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Supplementary Restraint System warning lamp indicates a fault |5.4.2| | 1 |
Brake pedal spongy |3.3.B.1b| | 1 |
Offside Rear Anti-roll bar linkage has excessive play in a pin/bush |2.4.G.2| | 1 |
Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Emissions not tested |7.4.B.1| | 1 |
Nearside Front Headlamp has a product on the light source so that the light output is severely reduced |1.7.5a| | 1 |
Offside Rear Brake hose excessively twisted (1.1.12 (b) (ii)) | 1 |
Brake hose damaged | 1 |
Nearside Front Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i)) | 1 |
Nearside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
Nearside Front Shock absorber has a serious fluid leak |2.7.3| | 1 |
Nearside Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sill has corrosion within 30cm of body mounting just below outrigger |see chalk| |6.2.2 |d| |i|| | 1 |
Offside Direction indicator adversely affected by the operation of another lamp |1.4.A.2h| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
Brake pedal creeps down when held under pressure |3.3.B.1a| | 1 |
Anti-lock braking system warning lamp indicates an ABS fault | 1 |
Offside Rear Position lamp not working Side light (4.2.1 (a) (ii)) | 1 |
Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Inner arch corroded (6.1.1 (c) (i)) | 1 |
Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Inner arch corroded (6.1.1 (c) (i)) | 1 |
Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Under bonnet bulkhead/arch corroded (6.1.1 (c) (i)) | 1 |
Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Inner arch corroded (Mounting point) (6.1.1 (c) (i)) | 1 |
Offside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt front ball joint |2.4.G.2| | 1 |