| Most common failures | No# failures |
|---|
| Parking brake: efficiency below requirements |3.7.B.7| | 5 |
| Service brake: efficiency below requirements |3.7.B.7| | 5 |
| Registration plate lamp issues | 5 |
| Brake pipe excessively corroded | 3 |
| Offside Rear position lamp|s| not working |1.1.A.3b| | 2 |
| Headlamp aim out of alignment | 2 |
| Nearside Rear Stop lamp not working |1.2.1b| | 2 |
| Rear parking brake recording little or no effort | 2 |
| Windscreen wiper does not clear the windscreen effectively | 2 |
| Nearside All position lamps not working |1.1.A.3b| | 2 |
| Brakes imbalanced across an axle | 2 |
| Brake load sensing valve defective and function impaired |3.6.E.3| | 2 |
| Nearside Stop lamp not working |1.2.1b| | 2 |
| Offside Stop lamp not working |1.2.1b| | 2 |
| Horn not working |1.6.2a| | 2 |
| Parking brake efficiency below requirements (1.4.2 (a) (i)) | 2 |
| Nearside Front Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Nearside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
| Offside Rear Front position lamp|s| not working |1.1.A.3b| | 1 |
| Brake load sensing valve linkage defective and function impaired |3.6.E.3| | 1 |
| Nearside Rear Anti-roll bar linkage corroded and seriously weakened |2.4.G.1| | 1 |
| Offside Rear Anti-roll bar linkage corroded and seriously weakened |2.4.G.1| | 1 |
| rear brake recording little or no effort |3.7.B.5a| | 1 |
| Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings Rear body mounting cross member corroded and holed |6.1.B.2| | 1 |
| Nearside Front Brake hose twisted |found during steering lock to lock check| |2.2.D.2b| | 1 |
| Offside Rear fog lamp does not emit a steady red light (4.5.4 (a)) | 1 |
| Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 1 |
| Offside Front Service brake excessively binding (1.2.1 (f)) | 1 |
| Brake hose excessively deteriorated | 1 |
| Parking brake lever has no reserve travel |3.1.6b| | 1 |
| Windscreen damaged and affecting the driver`s view of the road |3.2 |a| |ii|| | 1 |
| Rear Brake load sensing valve linkage defective and function impaired |1.1.17 |a|| | 1 |
| Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced near body mount |6.1.1 |c| |i|| | 1 |
| Rear Brake hose excessively damaged |3.6.B.4d| | 1 |
| Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i)) | 1 |
| Offside Rear Stop lamp not working |1.2.1b| | 1 |
| Nearside Stop lamp adversely affected by the operation of another lamp |1.2.1f| | 1 |
| Offside All position lamps not working |1.1.A.3b| | 1 |
| Brake load sensing valve seized |3.6.E.3| | 1 |
| Offside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
| Offside Rear Rear fog lamp not working |1.3.2b| | 1 |
| Headlamp not working on main beam |1.7.5a| | 1 |
| Direction indicators not in good working order |function impaired| |1.5.A1b| | 1 |
| Nearside Rear Leaf spring has a deteriorated shackle pin rubber bush resulting in excessive movement |2.4.B.2| | 1 |
| Offside Rear Leaf spring has a deteriorated shackle pin rubber bush resulting in excessive movement |2.4.B.2| | 1 |
| Nearside Body has excessive displacement which may lead to loss of vehicle control |6.1.B.1a| | 1 |
| Offside Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e| | 1 |
| Offside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
| Nearside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
| Brake hose damaged | 1 |
| Fuel system component insecure |7.2.1| | 1 |
| Brake load sensing valve has been disconnected and was fitted as standard |3.6.E.2| | 1 |
| Nearside Rear Rear position lamp|s| not working |1.1.A.3b| | 1 |
| Nearside Rear Brake pipe leaking |3.6.A.1| | 1 |
| Rear Additional braking device insecure |3.6.I.1| | 1 |
| Brake performance not tested |3.7.A.1| | 1 |
| Offside Rear fog lamp emits a light other than red |1.3.2e| | 1 |
| Nearside Upper Front position lamp|s| not working |1.1.A.3b| | 1 |
| Rear Exhaust has a major leak of exhaust gases silenser |7.1.2| | 1 |
| Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced |6.1.1 |c| |i|| | 1 |
| Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced |6.1.1 |c| |i|| | 1 |
| Offside Upper Rear position lamp|s| not working |1.1.A.3b| | 1 |
| Nearside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i)) | 1 |
| Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner wing to chassis (6.1.1 (c) (i)) | 1 |
| Anti-lock braking system warning lamp indicates an ABS fault | 1 |
| Offside Front Sub-frame corroded and seriously weakened around previous repair, previous repair also not fully seam welded (5.3.3 (b) (i)) | 1 |
| Nearside Front Sub-frame corroded and seriously weakened lower suspension arm rear mounting, bush worn through subframe (5.3.3 (b) (i)) | 1 |
| Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis rail holed, between bump stop and anti roll bar mounting (5.3.6 (a) (i)) | 1 |