Most common failures | No# failures |
---|
Headlamp aim out of alignment | 11 |
Brake pipe excessively corroded | 7 |
Parking brake efficiency below requirements (1.4.2 (a) (i)) | 6 |
Registration plate lamp issues | 6 |
Supplementary restraint system warning lamp indicates a fault (7.1.6 (a)) | 6 |
Windscreen wiper does not clear the windscreen effectively | 5 |
Brakes imbalanced across an axle | 3 |
Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 3 |
Nearside Front Direction indicator lens defective such that the emitted light is adversely affected (4.4.1 (b) (ii)) | 2 |
Rear Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 2 |
Offside Front Position lamp not working (4.2.1 (a) (ii)) | 2 |
Offside Rear Service brake excessively binding (1.2.1 (f)) | 2 |
Rear Parking brake efficiency below requirements nearside and offside (1.4.2 (a) (i)) | 2 |
Nearside Rear Direction indicator incorrect colour (4.4.3 (a)) | 2 |
Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 2 |
Nearside Front Upper Outline marker lamp not working (4.2.1 (a) (ii)) | 1 |
Offside Rear Upper Outline marker lamp not working (4.2.1 (a) (ii)) | 1 |
Offside Rear Upper Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
Hazard warning switch inoperative (4.4.2 (a) (ii)) | 1 |
Offside Side repeater not working (4.4.1 (a) (ii)) | 1 |
Exhaust emissions exceed manufacturer`s specified limit |8.2.2.2 |a|| | 1 |
Nearside Front Upper Suspension component ball joint dust cover no longer prevents the ingress of dirt tie rod (5.3.4 (b) (ii)) | 1 |
Offside Front Upper Suspension component ball joint dust cover no longer prevents the ingress of dirt tie rod (5.3.4 (b) (ii)) | 1 |
Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner |6.1.B.2| | 1 |
Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner sill |6.1.B.2| | 1 |
Offside Exhaust has a major leak of exhaust gases exhaust tailpipe section |7.1.2| | 1 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Nearside Front Position lamp not working |4.2.1 |a|| | 1 |
Supplementary restraint system warning lamp indicates a fault |7.1.6 |a|| | 1 |
Brake performance not tested |1.2.1 |g|| | 1 |
Offside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
Rear fog lamp switch not operating in accordance with the requirements (4.5.3 (a)) | 1 |
Offside Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
Nearside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
Offside Outline marker lamp with a multiple light source more than 1/2 not functioning (4.2.1 (a) (ii)) | 1 |
Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i)) | 1 |
Nearside Rear Service brake excessively binding (1.2.1 (f)) | 1 |
Offside Headlamp not working on dipped beam |4.1.1 |a| |ii|| | 1 |
Offside Rear fog lamp not working |1.3.2b| | 1 |
rear parking |secondary| brakes imbalanced | 1 |
Nearside Cab or chassis has excessive corrosion to the extent that overall security or stability of the cab is impaired Rear of cab (6.2.2 (d) (ii)) | 1 |
Bumper likely to become detached O/S and N/S mounts corroded (6.1.4 (a) (ii)) | 1 |
Central Exhaust has a major leak of exhaust gases Front pipe to back box (6.1.2 (a)) | 1 |
Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Crossmember over rear axle (6.1.1 (c) (i)) | 1 |
Brake performance not tested (1.2.1 (g)) | 1 |
Offside Rear Direction indicators not working |1.4.A.2c| | 1 |
Nearside Front Inner Suspension arm has excessive play in a pin/bush |2.4.G.2| | 1 |
Offside Rear Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
Offside Front Lower Cab or chassis has excessive corrosion to the extent that overall security or stability of the cab is impaired (6.2.2 (d) (ii)) | 1 |
Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Nearside Front Outer Suspension arm ball joint excessively worn (5.3.4 (a) (i)) | 1 |
Nearside Front Inner Suspension arm pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
Offside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Inner Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill /out rigger holed |6.1.B.2| | 1 |
Nearside Front Panhard rod ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Nearside Front Seat belt buckle not functioning as intended |7.1.2 |d|| | 1 |
Offside Front Inner Track rod end ball joint has excessive play steering arm joint. |2.1.3 |b| |i|| | 1 |
Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill box section . |5.3.6 |a| |i|| | 1 |
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill box section. |5.3.6 |a| |i|| | 1 |
Battery insecure and likely to fall from carrier |4.13 |a| |ii|| | 1 |
Offside Front Headlamp aim projected beam image is obviously incorrect |4.1.2 |c|| | 1 |
Offside Outline marker lamp not working (4.2.1 (a) (ii)) | 1 |
Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
Offside Front Headlamp not working on main beam (4.1.1 (a) (ii)) | 1 |
Electrical wiring insulation in such a condition there is an imminent risk of fire or formation of sparks wiring rubbing on cooling fan (4.11 (c) (iii)) | 1 |
Nearside Front Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting inner arch (6.2.2 (d) (i)) | 1 |
Offside Front Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting inner arch (6.2.2 (d) (i)) | 1 |
Nearside Inner Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings box section badly corroded |6.1.B.2| | 1 |
Offside Inner Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings box section |6.1.B.2| | 1 |
Parking brake is not capable of being maintained in operation by direct mechanical action only |3.1.2| | 1 |
Parking brake lever has no reserve travel |3.1.6b| | 1 |
Electronic stability system warning lamp indicates a fault |3.4.1c| | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Parking brake: efficiency below requirements |3.7.B.7| | 1 |
Central Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 1 |
Rear Exhaust has a major leak of exhaust gases pipe corroded (6.1.2 (a)) | 1 |
Nearside Rear Brake disc significantly and obviously worn (1.1.14 (a) (i)) | 1 |
Offside Rear Brake disc significantly and obviously worn (1.1.14 (a) (i)) | 1 |
Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
Nearside Front Service brake excessively binding (1.2.1 (f)) | 1 |
Rear Anti-roll bar pin or bush excessively worn nearside and offside (5.3.4 (a) (i)) | 1 |
Emissions not tested (8.2.2.2 (e)) | 1 |
Fuel cap/sealing device ineffective (6.1.3 (b) (i)) | 1 |
Offside Rear Rear fog lamp light intensity significantly reduced (4.5.4 (a)) | 1 |
Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i)) | 1 |
Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i)) | 1 |
Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i)) | 1 |
Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
Prop shaft bearing excessively worn (6.1.7 (b) (i)) | 1 |
Rear Brake pipe at imminent risk of failure or fracture severely corroded and failed under pressure (1.1.11 (a)) | 1 |
Nearside Rear Service brake has no recorded effort at a wheel due to metal brake pipe failure (1.2.1 (a) (ii)) | 1 |
Offside Rear Stop lamp(s) adversely affected by the operation of another lamp (4.3.3 (b)) | 1 |
Offside Rear Direction indicator adversely affected by the operation of another lamp (4.4.3 (b)) | 1 |
Anti-lock braking system warning lamp indicates an ABS fault | 1 |
Central Seat belt missing buckle (7.1.2 (a)) | 1 |
Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
Rear fog lamp tell-tale not working (4.9.1 (a) (ii)) | 1 |
Offside Front Suspension arm ball joint excessively worn inner front joint (5.3.4 (a) (i)) | 1 |
Offside Front Suspension arm pin or bush excessively worn inner rear bush (5.3.4 (a) (i)) | 1 |
Offside Track rod end ball joint has excessive play (2.1.3 (b) (i)) | 1 |
Offside Rear Vehicle structure is fractured and structural rigidity is significantly reduced chassis leg (6.1.1 (a) (i)) | 1 |
Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
Offside Rear Rear fog lamp does not emit a steady red light (4.5.4 (a)) | 1 |
Brake pedal has insufficient reserve travel (1.1.2 (a)) | 1 |
Nearside Front Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner wing / body mouting (6.1.1 (c) (i)) | 1 |
Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) | 1 |