Most common failures | No# failures |
---|
Nearside front brake binding |3.7.B.1| | 2 |
Registration plate lamp issues | 2 |
Nearside front brake recording little or no effort |3.7.B.5a| | 2 |
Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 2 |
Offside front brake recording little or no effort |3.7.B.5a| | 2 |
Offside front brake binding |3.7.B.1| | 2 |
Nearside Stop lamp not working |1.2.1b| | 2 |
Windscreen has damage | 2 |
Offside Rear Body insecure and dangerous to other road users |6.1.B.1b| | 1 |
Offside Front Steering rack gaiter insecure |2.2.D.2d| | 1 |
Horn not working |1.6.2a| | 1 |
Nearside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Battery insecure |1.9.1| | 1 |
Nearside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Offside Front Brake hose stretched |found during steering lock to lock check| |2.2.D.2b| | 1 |
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear Vehicle structure excessively corroded within 30cm of towbar mounting |6.6.6| | 1 |
Offside Rear Vehicle structure excessively corroded within 30cm of towbar mounting |6.6.6| | 1 |
Service brake: efficiency below requirements |3.7.C.1a| | 1 |
Nearside Front Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) | 1 |
Nearside Front Service brake excessively binding (1.2.1 (f)) | 1 |
Offside Headlamp lens missing (4.1.1 (b) (ii)) | 1 |
Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) | 1 |
Hazard warning tell tale not working correctly |1.4.B.1e| | 1 |
Nearside Side repeater not working |1.4.A.2c| | 1 |
Nearside Rear Brake pipe inadequately clipped |3.6.B.1| | 1 |
Offside Front Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) | 1 |
Nearside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Nearside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Brakes imbalanced across an axle | 1 |
Offside Front Headlamp not working on main beam |1.7.5a| | 1 |
Offside Stop lamp not working |1.2.1b| | 1 |
Offside Rear Brake pipe inadequately clipped |3.6.B.1| | 1 |
Nearside Side repeater missing |1.4.A.2b| | 1 |
Offside Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Offside Rear Direction indicator not working |1.4.A.2c| | 1 |
Offside Rear fog lamp adversely affected by the operation of another lamp |1.3.2f| | 1 |
Headlamp aim out of alignment | 1 |
Nearside Front Body has a sharp edge caused by damage |6.1.C.1| | 1 |
Offside Front Body has a sharp edge caused by damage |6.1.C.1| | 1 |
Nearside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Nearside Rear Direction indicators not working |1.4.A.2c| | 1 |
Offside Rear fog lamp not working |1.3.2b| | 1 |
Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f| | 1 |
Offside Front Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Nearside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Nearside Front Statutory seat belt missing |5.1.1| | 1 |
Registration plate issues | 1 |
Nearside Headlamp not in good working order |not working| |1.2.4a| | 1 |
Exhaust has a part missing |7.1.1a| | 1 |
Brake pipe excessively corroded | 1 |
Front Drag link end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Offside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement |7.2.4b| | 1 |