>

MOT History from tests of diesel IVECO-FORD DAILYs year 1987

Review the list of common IVECO-FORD DAILY failures below or to perform a specific mot history check on your IVECO-FORD then use our popular KnowYourCar service

mot history
Pass percent:35.00%
(The average a diesel IVECO-FORD DAILY year 1987 passes without issue)
Based on:20 MOT Tests
Most common failuresNo# failures
Windscreen wiper does not clear the windscreen effectively5
Service brake: efficiency below requirements |3.7.B.7|4
Rear brake application uneven4
Brake pipe excessively corroded4
Registration plate lamp issues3
Headlamp aim out of alignment2
Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Inner arch (6.2.2 (d) (i))1
Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Inner arch (6.2.2 (d) (i))1
Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced Step corroded (7.1.1 (a) (i))1
Offside Seat belt anchorage prescribed area strength or continuity significantly reduced Step corroded (7.1.1 (a) (i))1
Bonnet cannot be secured in the closed position (3.1 (b) (i))1
Nearside Front Side repeater not working (4.4.1 (a) (ii))1
Nearside Rear Direction indicator not working (4.4.1 (a) (ii))1
Offside Rear Position lamp with a multiple light source more than 1/2 not functioning (4.2.1 (a) (ii))1
Rear fog lamp tell-tale not working |4.9.1 |a| |ii||1
Nearside Side repeater not working |4.4.1 |a| |ii||1
Windscreen washer not working 1
Offside Headlamp not working on dipped beam |1.7.5a|1
Fuel system component insecure |7.2.1|1
Offside Front Track rod end ball joint has excessive play |2.2.B.1f|1
Offside rear brake recording little or no effort |3.7.B.5a|1
Bonnet cannot be secured in the closed position |8.4.1|1
Nearside Front Upper Suspension component mounting prescribed area is excessively corroded |2.4.A.3|1
Offside Front Lower Body has a sharp edge caused by corrosion |6.1.C.1|1
Nearside Rear Leaf spring has excessive wear in a shackle pin and/or bush |2.4.B.2|1
Offside Rear Leaf spring has excessive wear in a shackle pin and/or bush |2.4.B.2|1
Rear Axle has inadequate clearance with the bump stop |2.4.A.1a|1
Nearside Front Body has a sharp edge caused by corrosion |6.1.C.1|1
Offside Front Body has a sharp edge caused by corrosion |6.1.C.1|1
Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2|1
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2|1
Offside Headlamp aim beam image obviously incorrect |1.8.A.1b|1
Nearside Front Inner Cab or chassis has excessive corrosion to the extent that overall security or stability of the cab is impaired arch |6.2.2 |d| |ii||1
Nearside Inner Cab or chassis has excessive corrosion to the extent that overall security or stability of the cab is impaired step |6.2.2 |d| |ii||1
Nearside Outer Cab or chassis has excessive corrosion to the extent that overall security or stability of the cab is impaired sill |6.2.2 |d| |ii||1
Offside Front Cab or chassis has excessive corrosion to the extent that overall security or stability of the cab is impaired sill |6.2.2 |d| |ii||1
Offside Inner Cab or chassis has excessive corrosion to the extent that overall security or stability of the cab is impaired sill holed |6.2.2 |d| |ii||1
Nearside Front Front position lamp|s| has less than 50% of the light sources illuminating |1.1.A.3b|1
Headlamp switch faulty |1.7.1|1
Windscreen wiper not operating automatically when switched on |8.2.1b|1
Rear fog lamp not working |1.3.2b|1
Nearside Headlamp excessively deteriorated so that the light output is severely reduced |1.7.5a|1
Offside Headlamp excessively deteriorated so that the light output is severely reduced |1.7.5a|1
Nearside Front Body has a projection caused by corrosion |6.1.C.1|1
Offside Front Body has a projection caused by corrosion |6.1.C.1|1
Front Body has a projection caused by corrosion |6.1.C.1|1
Nearside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6|1
Offside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6|1
Access panel cannot be secured in the closed position |6.4.1|1
Front Exhaust has part of the system excessively deteriorated |7.1.1a|1
Nearside Headlamp insecure |1.7.3|1
Offside Headlamp insecure |1.7.3|1
Nearside Front Service brake excessively binding (1.2.1 (f))1
Offside Inner Rear Road wheel badly damaged |4.2.A.1a|1
Brakes imbalanced across an axle1
Front Headlamp not in good working order adversely affecting beam image |1.2.4a|1
Offside Front Direction indicator not working |1.4.A.2c|1

We get to these numbers by trawling through over 1 billion MOT test results since 2004 and crunched the numbers. We remove anything to do with Tyres, as they are model independent and group together common non-model specific issues. We are trying to get to a picture of what models have what issues.

Please note: We take the data from the DVSA. This data is raw and can contain typos and spelling mistakes that garages may have entered while recording a MOT result. Specifically miss-match on names of models and makes. We are constantly cleaning the data so bear with the odd issue.

Got suggestions? We’re improving this section all the time. If you have any suggestions, please let us know.

Find us on Facebook

© KnowYourCar™ 2019. All rights reserved
Except where otherwise noted, content on our MOT statistics pages are licensed under a Creative Commons Attribution 4.0 International license.
You are free to redistribute the material in any medium or format as long as credit is given to KnowYourCar

WARNING: We have placed hidden watermarks in our data. We will take action against our data being used outside of these terms.

MOT Data licensed under the Open Government Licence v3.0

By using our site you are agreeing to our terms and conditions
Terms & Conditions  Privacy Policy