>

MOT History from tests of petrol HONDA NT650V-2s year 2003

Review the list of common HONDA NT650V-2 failures below or to perform a specific mot history check on your HONDA then use our popular KnowYourCar service

mot history
Pass percent:88.59%
(The average a petrol HONDA NT650V-2 year 2003 passes without issue)
Based on:1,245 MOT Tests
Most common failuresNo# failures
Headlamp aim out of alignment28
Nearside Front shock absorber seal failed and leaking oil |2.3.3|10
Front Stop lamp does not illuminate immediately a brake applies |1.3.1a|7
Stop lamp does not illuminate immediately a brake applies |1.3.1a|5
Front Roller brake test indicates a binding brake |3.3.A1a|5
Steering movement excessively `notchy` with the wheel raised |2.2.1b|5
Offside Front shock absorber seal failed and leaking oil |2.3.3|5
Roller brake test The less effective brake control does not achieve an efficiency of 25%. |3.3.A2b|4
Exhaust is leaking and excessively noisey |7.1.1b|4
Headlamp aim beam image kick up to the offside |1.6|4
Stop lamp remains on when the brakes are released4
Front Brake excessively binding (1.2.1 (f))4
Offside Front Front shock absorber seal failed and leaking oil |2.3.3|3
Nearside Front Front shock absorber seal failed and leaking oil |2.3.3|3
Rear Brake disc|s| excessively worn |3.2.A1l|3
Rear Roller brake test indicates a binding brake |3.3.A1a|3
Roller brake test The less effective brake control does not achieve an efficiency of 25% |1.2.2 |a| |i||3
Front shock absorber seal failed and leaking oil |2.3.3|3
Rear Brake excessively binding (1.2.1 (f))3
Roller brake test The less effective brake control does not achieve an efficiency of 25% (1.2.2 (a) (i))3
Offside Front Shock absorber has a serious fluid leak (5.3.2 (b))3
Rear Roller brake test indicates a sticking brake |3.3.A1a|2
Front Roller brake test indicates a sticking brake |3.3.A1a|2
Steering movement excessively `notchy` with the weight on the lower bearing |2.2.1a|2
Rear Brake pedal cannot be released smoothly |3.1.3d|2
Front Front wheel bearings have excessive free play |2.3.5b|2
Horn not working |1.7.3a|2
Throttle operating incorrectly |6.2.1f|2
Offside Front Shock absorber has a serious fluid leak |5.3.2 |b||2
Rear Brake excessively binding |1.2.1 |f||2
Rear Brake pedal has inadequate reserve travel |3.1.3b|2
Registration plate lamp issues2
Front Position lamp not working (4.2.1 (a))2
Front Brake indicates excessive fluctuation of brake effort (1.2.1 (e))2
Nearside Front Shock absorber has a serious fluid leak (5.3.2 (b))2
Exhaust has a major leak of exhaust gases |6.1.2 |a||1
Front Stop lamp not working |4.3.1 |a| |ii||1
Rear Brake component has restricted free movement and operation is likely to be impeded |3.2.A1h|1
Front Brake lever has inadequate reserve travel |3.1.3b|1
Fuel hose leaking |7.2.1a|1
Rear Stop lamp remains on when the brake is released |1.3.1e|1
Nearside Steering control has Insufficient clearance at full lock affecting the riders operation of the controls |2.1.2b|1
Offside Steering control has Insufficient clearance at full lock affecting the riders grasp of handlebars |2.1.2b|1
Front Floor brake test indicates a sticking brake |3.3.C2c|1
Nearside Front Shock absorber has a serious fluid leak |5.3.2 |b||1
Front wheel bearings are excessively rough |2.3.5b|1
Front suspension assembly component excessively corroded. front legs badly pitted |2.3.1|1
Front suspension has inadequate damping effect. front forks bottom out |2.3.6c|1
Rear Brake effort inadequate at a wheel |1.2.1 |a| |i||1
Front Exhaust excessively deteriorated |7.1.1a|1
Rear Exhaust excessively deteriorated |7.1.1a|1
Exhaust noise is clearly in excess of that emitted by a similar motor bicycle fitted with a standard silencer in average condition |7.1.2|1
Steering control handlebar movement restricted by taut cables |2.1.2c|1
Fuel system component insecure |7.2.1b|1
Offside Exhaust excessively deteriorated |7.1.1a|1
Upper Shock absorber has an excessively worn bush |5.3.2 |c||1
Indicator switch defective |1.5.4|1
Front Brake lever mounting insecure |3.1.2a|1
Rear Brake disc|s| cracked |3.2.A1g|1
Centre Rear Rear position lamp damaged and function impaired |1.1.1b|1
Offside Front Brake disc|s| has excessive run out |3.2.A1m|1
Front Roller brake test indicates excessive fluctuation of brake effort |3.3.A1d|1
Fuel cap sealing washer missing |7.2.2c|1
Front Front wheel bearings are excessively rough |2.3.5b|1
Front Steering movement excessively `notchy` with the wheel raised |2.2.1b|1
All direction indicators not working |4.4.1 |a| |ii||1
Rear mono-shock pivot excessively worn |2.4.B.4|1
Rear mono-shock insecure |2.4.B.4|1
Front Front position lamp does not illuminate immediately when switched on |1.1.3a|1
Nearside Front Indicator tell tale not functioning |1.5.2|1
Rear Valve stem seriously damaged |5.2.3 |j||1
Throttle operating incorrectly sticking and excesively high idle speed |6.2.1f|1
All position lamps adversely affected by the operation of another lamp |1.1.3b|1
Nearside Front Direction indicators not working |1.5.1c|1
Rear Floor brake test indicates a sticking brake |3.3.C2c|1
Fuel cap ineffective Can not access |6.1.3 |b| |i||1
Offside Rear Exhaust excessively deteriorated |7.1.1a|1
Steering headbearing has excessive free play |2.2.2|1
Nearside Front Direction indicator not working |1.5.1c|1
Nearside Rear Direction indicator not working |1.5.1c|1
Rear wheel bearings have excessive free play |2.4.A.2c|1
Rear Brake pedal cannot be applied smoothly |3.1.3d|1
Roller brake test indicates a binding brake |3.3.A1a|1
Front Headlamp aim beam image kick-up is to the offside |1.6.1|1
Front Floor brake test indicates a binding brake |3.3.C2c|1
Handlebar fouling on the fuel tank or bodywork on full lock |2.1.4 |b||1
Handlebar excessively deformed |2.2.1 |c| |i||1
Rear Position lamp not working |4.2.1 |a||1
Brake disc significantly and obviously worn below minimum thickness , measured at 4.3mm spec 5mm |1.1.14 |a| |i||1
Offside Front Fuel pipe leaking |7.2.1a|1
Nearside Rear Exhaust mounting does not fully support the exhaust system |7.1.1.c|1
Rear Brake disc fractured |1.1.14 |a| |ii||1
Front Brake disc|s| friction surface contaminated by oil or grease |3.2.A1k|1
Headlamp at least one does not illuminate on dipped beam |1.2.2a|i||1
Front wheel bearings have excessive free play |2.3.5b|1
Rear Stop lamp does not illuminate immediately a brake applies |1.3.1a|1
Front Brake excessively binding |1.2.1 |f||1
Exhaust is leaking and excessively noisey down pipes |7.1.1b|1
Front Steering movement excessively rough with the weight on the lower bearing |2.2.1a|1
Centre Front Horn not working |1.7.3a|1
Front Steering movement excessively `notchy` with the weight on the lower bearing |2.2.1a|1
Front Headlamp dipped beam affected by the operation of another lamp |1.2.2c|1
Front Headlamp main beam affected by the operation of another lamp |1.2.2c|1
Rear Rear position lamp adversely affected by the operation of another lamp |1.1.3b|1
Front Upper Fairing so located that it is likely to impede the steering |2.1.2e|1
Registration plate issues1
Headlamp not working on dipped beam (4.1.1 (a) (ii))1
Riders seat insecure (6.2.5 (a) (ii))1
Exhaust has a major leak of exhaust gases (6.1.2 (a))1
Front Brake caliper excessively weakened by corrosion (1.1.16 (d) (i))1
Rear Brake caliper excessively weakened by corrosion (1.1.16 (d) (i))1
Brake performance not tested (1.2.1 (g))1
Exhaust silencer insecure (8.1.1 (b) (i))1
Front Exhaust has a major leak of exhaust gases (6.1.2 (a))1
Rear Brake indicates excessive fluctuation of brake effort (1.2.1 (e))1
Front Wheel fixing loose (multiple fixings) (5.2.1 (a) (i))1
Central Rear Inner Suspension arm ball joint excessively worn (5.3.4 (a) (i))1
Steering headbearing excessively stiff or notchy (2.2.2 (f) (i))1
Upper Steering headbearing excessively stiff or notchy (2.2.2 (f) (i))1
Lower Steering headbearing excessively stiff or notchy (2.2.2 (f) (i))1
Rear Position lamp adversely affected by the operation of another lamp (4.2.3 (b))1
Front Position lamp adversely affected by the operation of another lamp (4.2.3 (b))1
Hazard warning lamps not fitted (4.4.1 (d))1
Nearside Rear Stop lamp(s) missing (4.3.1 (a) (ii))1
Offside Rear Stop lamp(s) missing (4.3.1 (a) (ii))1
Front Wheel bearing rough when rotated (5.1.3 (b) (i))1
Rear Brake has no recorded effort at a wheel (1.2.1 (a) (ii))1
Position lamp switch does not operate in accordance with the requirements main light switch broken (4.2.2 (a))1
Rear Shock absorber insecurely attached bottom shock bolt loose (5.3.2 (a) (i))1

We get to these numbers by trawling through over 1 billion MOT test results since 2004 and crunched the numbers. We remove anything to do with Tyres, as they are model independent and group together common non-model specific issues. We are trying to get to a picture of what models have what issues.

Please note: We take the data from the DVSA. This data is raw and can contain typos and spelling mistakes that garages may have entered while recording a MOT result. Specifically miss-match on names of models and makes. We are constantly cleaning the data so bear with the odd issue.

Got suggestions? We’re improving this section all the time. If you have any suggestions, please let us know.

Find us on Facebook

© KnowYourCar™ 2019. All rights reserved
Except where otherwise noted, content on our MOT statistics pages are licensed under a Creative Commons Attribution 4.0 International license.
You are free to redistribute the material in any medium or format as long as credit is given to KnowYourCar

WARNING: We have placed hidden watermarks in our data. We will take action against our data being used outside of these terms.

MOT Data licensed under the Open Government Licence v3.0

By using our site you are agreeing to our terms and conditions
Terms & Conditions  Privacy Policy