| Most common failures | No# failures |
|---|
| Windscreen wiper does not clear the windscreen effectively | 15 |
| Brake pipe excessively corroded | 12 |
| Parking brake: efficiency below requirements |3.7.B.7| | 7 |
| Brake hose excessively deteriorated | 7 |
| Headlamp aim out of alignment | 7 |
| Anti-lock braking system warning lamp indicates an ABS fault | 7 |
| Rear parking brake recording little or no effort | 5 |
| Registration plate lamp issues | 5 |
| Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 3 |
| Offside Stop lamp not working |1.2.1b| | 3 |
| Parking brake efficiency below requirements (1.4.2 (a) (i)) | 2 |
| Offside Front Suspension arm rubber bush bonding deteriorated resulting in excessive movement |2.4.G.2| | 2 |
| Parking brake efficiency below requirements |1.4.2 |a| |i|| | 2 |
| Offside Front Anti-roll bar has excessive play in a ball joint |2.4.G.2| | 2 |
| Registration plate issues | 2 |
| Nearside Front Headlamp not working on dipped beam |1.7.5a| | 2 |
| Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h)) | 2 |
| Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c)) | 1 |
| Exhaust emissions likely to be affected by an exhaust leak Centre section (8.2.1.1 (b)) | 1 |
| Nearside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b)) | 1 |
| Offside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b)) | 1 |
| Rear brake binding | 1 |
| Offside rear brake excessively fluctuating |3.7.B.3| | 1 |
| Offside Rear Wheel nut|s| missing |4.2.A.1e| | 1 |
| Bootlid cannot be secured in the closed position |6.4.1| | 1 |
| Nearside Rear Seat belt locking mechanism does not secure or release |5.2.5a| | 1 |
| Windscreen has damage | 1 |
| Bonded suspension unit deteriorated and cannot function as intended |2.4.F.3| | 1 |
| Nearside Rear brake disc excessively pitted |3.5.1h| | 1 |
| Offside Rear brake disc excessively pitted |3.5.1h| | 1 |
| Mechanical brake component has restricted free movement | 1 |
| Nearside Front Side repeater not working |1.4.A.2c| | 1 |
| Exhaust has a major leak of exhaust gases |6.1.2 |a|| | 1 |
| Nearside Front Anti-roll bar linkage ball joint excessively worn |5.3.4 |a| |i|| | 1 |
| Offside Front Suspension arm pin or bush likely to become detached wishbone rear bush |5.3.4 |a| |ii|| | 1 |
| Offside Rear Brake disc contaminated |1.1.14 |b|| | 1 |
| Parking brake lever has no reserve travel |3.1.6b| | 1 |
| Offside Front Lower Suspension arm pin or bush likely to become detached rear bush (5.3.4 (a) (ii)) | 1 |
| Rear Exhaust has a major leak of exhaust gases rear box (6.1.2 (a)) | 1 |
| Emissions not tested as exhaust rear box leaking (8.2.1.2 (d)) | 1 |
| Nearside Stop lamp not working |1.2.1b| | 1 |
| Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Central Rear Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
| Nearside Side repeater not working (4.4.1 (a) (ii)) | 1 |
| Offside Rear Brake pipe leaking on a hydraulic braking system (1.1.11 (b) (ii)) | 1 |
| Offside Front Lower Suspension arm pin or bush likely to become detached wishbone rear bush (5.3.4 (a) (ii)) | 1 |
| Front Brake disc significantly and obviously worn (1.1.14 (a) (i)) | 1 |
| Nearside Rear Service brake excessively binding (1.2.1 (f)) | 1 |
| Brake performance not tested as brake pipe leaking (1.2.1 (g)) | 1 |
| Offside Front Track rod end modification unsafe SAFETY PIN MISSING (2.1.3 (f) (i)) | 1 |
| Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i)) | 1 |
| Nearside Rear Hydraulic brake calliper leaking (1.1.16 (b) (i)) | 1 |
| Brakes imbalanced across an axle | 1 |
| Offside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Centre Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Nearside Front Suspension arm pin or bush excessively worn REAR BUSH (5.3.4 (a) (i)) | 1 |
| Offside Front Suspension arm pin or bush excessively worn REAR BUSH (5.3.4 (a) (i)) | 1 |
| Brake fluid warning lamp illuminated |3.6.G.2| | 1 |
| Nearside Rear Braking system leaking |3.6.A.1| | 1 |
| Brake hydraulic reservoir fluid level below minimum level |3.6.G.1b| | 1 |
| Nearside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
| Centre Rear Brake pipe leaking |3.6.A.1| | 1 |
| Service brake: efficiency below requirements |3.7.B.7| | 1 |
| Parking brake inoperative on one side both sides parking brake effort low |1.4.1 |a|| | 1 |
| Nearside Front Headlamp not working on dipped beam |4.1.1 |a| |ii|| | 1 |
| Offside Front Position lamp not working |4.2.1 |a|| | 1 |
| Suspension arm pin or bush excessively worn nearside front suspension arm bush bonding split and excessive movement |5.3.4 |a| |i|| | 1 |
| Suspension component mounting prescribed area excessively corroded significantly reducing structural strength offside rear inner sill corroded and holed |5.3.6 |a| |i|| | 1 |
| Suspension component mounting prescribed area fractured significantly reducing structural strength nearside rear chassis leg corroded and split |5.3.6 |a| |i|| | 1 |
| Offside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
| Offside Rear Stop lamp not working |1.2.1b| | 1 |
| Offside Front Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
| Nearside Front Lower Suspension arm has excessive play in a pin/bush |2.4.G.2| | 1 |
| Offside Rear Rear wheel bearing rough when rotated |2.6.1| | 1 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded spring mount |2.4.A.3| | 1 |
| Nearside Rear Suspension component mounting prescribed area is excessively corroded axel mount |2.4.A.3| | 1 |
| Parking brake: efficiency below requirements |3.7.D.4| | 1 |
| Windscreen wiper blade insecure | 1 |
| Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Nearside Front Anti-roll bar has excessive play in a ball joint |2.4.G.2| | 1 |
| Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 1 |
| Central Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 1 |
| Offside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
| Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Offside Side repeater not working (4.4.1 (a) (ii)) | 1 |
| Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 1 |
| Emissions not tested (8.2.1.2 (d)) | 1 |
| Brake performance not tested (1.2.1 (g)) | 1 |
| Rear Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 1 |
| Emissions unable to be completed (8.2.1.2 (d)) | 1 |
| Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
| Offside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Nearside Front Road wheel fixing missing (5.2.1 (a) (i)) | 1 |
| Nearside Front Anti-roll bar ball joint excessively worn (5.3.4 (a) (i)) | 1 |
| Offside Rear Parking brake inoperative on one side (1.4.1 (a)) | 1 |
| Front brake application uneven | 1 |
| Exhaust emissions carbon monoxide content at idle excessive |7.3.D.4| | 1 |
| Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 1 |