Most common failures | No# failures |
---|
Headlamp aim out of alignment | 135 |
Registration plate issues | 87 |
Windscreen wiper does not clear the windscreen effectively | 53 |
Registration plate lamp issues | 46 |
Headlamp aim beam image kick up to the offside |1.6| | 38 |
Brake pipe excessively corroded | 35 |
Rear reflector on motorcycle missing |1.4.1| | 31 |
Rear Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 27 |
Parking brake: efficiency below requirements |3.7.B.7| | 24 |
Offside Front shock absorber seal failed and leaking oil |2.3.3| | 23 |
Drive chain excessively loose |6.2.1d| | 22 |
Nearside Front shock absorber seal failed and leaking oil |2.3.3| | 21 |
Rear position lamp does not illuminate immediately when it is switched on |1.1.3a| | 20 |
Exhaust emissions Lambda reading after 2nd fast idle outside specified limits |7.3.D.3| | 20 |
Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 18 |
Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 18 |
Front Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 18 |
Offside Front constant velocity joint gaiter split |2.5.C.1a| | 17 |
Roller brake test The less effective brake control does not achieve an efficiency of 25%. |3.3.A2b| | 17 |
Steering movement excessively `notchy` with the wheel raised |2.2.1b| | 16 |
Nearside Stop lamp not working |1.2.1b| | 16 |
Offside Stop lamp not working |1.2.1b| | 16 |
Steering headbearing has excessive free play |2.2.2| | 15 |
Throttle operating incorrectly |6.2.1f| | 15 |
Headlamp at least one does not illuminate on dipped beam |1.2.2a|i|| | 14 |
Front Roller brake test indicates a binding brake |3.3.A1a| | 14 |
Front wheel bearings have excessive free play |2.3.5b| | 13 |
Exhaust emissions carbon monoxide content at idle excessive |7.3.D.4| | 13 |
Nearside Rear Stop lamp not working |1.2.1b| | 13 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 13 |
Offside Front position lamp|s| not working |1.1.A.3b| | 13 |
Exhaust is leaking and excessively noisey |7.1.1b| | 13 |
Rear Rear reflector on motorcycle missing |1.4.1| | 13 |
Front Roller brake test indicates excessive fluctuation of brake effort |3.3.A1d| | 11 |
Offside Rear Stop lamp not working |1.2.1b| | 11 |
Nearside Front constant velocity joint gaiter split |2.5.C.1a| | 11 |
Rear parking brake recording little or no effort | 11 |
Rear brake binding | 10 |
Anti-lock braking system warning lamp indicates an ABS fault | 10 |
Centre Exhaust has a major leak of exhaust gases |7.1.2| | 10 |
Drive chain worn to excess |6.2.1e| | 10 |
Rear Rear wheel bearings have excessive free play |2.4.A.2c| | 10 |
Horn not working |1.7.3a| | 10 |
Exhaust has a major leak of exhaust gases |7.1.2| | 9 |
Offside Front Front constant velocity joint gaiter split |2.5.C.1a| | 9 |
Nearside Front Front shock absorber seal failed and leaking oil |2.3.3| | 9 |
Drive chain excessively tight |6.2.1d| | 9 |
Rear Drive chain sprocket worn to excess |6.2.1e| | 9 |
Nearside Rear Trailing arm rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 9 |
Rear wheel bearings have excessive free play |2.4.A.2c| | 9 |
Rear Brake lever has inadequate reserve travel |3.1.3b| | 9 |
Offside Front Front position lamp|s| not working |1.1.A.3b| | 8 |
Nearside Rear Anti-roll bar linkage has excessive play in a ball joint |2.4.G.2| | 8 |
Rear Exhaust has a major leak of exhaust gases |7.1.2| | 8 |
Nearside Handlebar handgrip not secure to handlebars. |2.1.1c| | 8 |
Offside Front Front shock absorber seal failed and leaking oil |2.3.3| | 8 |
Rear shock absorber has inadequate damping effect. |2.4.A.3b| | 8 |
Front position lamp does not illuminate immediately when switched on |1.1.3a| | 8 |
Nearside Front Front constant velocity joint gaiter split |2.5.C.1a| | 7 |
Nearside Steering rack gaiter split |2.2.D.2d| | 7 |
Front wheel bearings are excessively rough |2.3.5b| | 7 |
Emissions not tested |7.0| | 7 |
Front shock absorber seal failed and leaking oil |2.3.3| | 7 |
Offside Rear Shock absorber has a serious fluid leak |2.7.3| | 7 |
Front Floor brake test indicates a binding brake |3.3.C2c| | 7 |
Headlamp at least one does not illuminate on main beam |1.2.2a|ii|| | 7 |
Rear Roller brake test indicates a binding brake |3.3.A1a| | 7 |
Nearside Rear Direction indicators not working |1.5.1c| | 7 |
Nearside Rear Direction indicator not working |1.5.1c| | 7 |
Offside Rear Trailing arm rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 7 |
Front Headlamp aim beam image kick up to the offside |1.6| | 7 |
Windscreen has damage | 6 |
Brakes imbalanced across an axle | 6 |
Horn not working |1.6.2a| | 6 |
Rear fog lamp tell tale not working |1.3.1b| | 6 |
Offside Rear fog lamp not working |1.3.2b| | 6 |
Front Front wheel bearings have excessive free play |2.3.5b| | 6 |
Exhaust emissions hydrocarbon content after 2nd fast idle excessive |7.3.D.3| | 6 |
Offside Headlamp not working on dipped beam |1.7.5a| | 6 |
Nearside Front Direction indicators not working |1.5.1c| | 6 |
Nearside Front Front position lamp|s| not working |1.1.A.3b| | 6 |
Rear Brake disc|s| excessively worn |3.2.A1l| | 6 |
Nearside Front Direction indicator not working |1.5.1c| | 6 |
Exhaust noise is clearly in excess of that emitted by a similar motor bicycle fitted with a standard silencer in average condition |7.1.2| | 6 |
Front Brake excessively binding (1.2.1 (f)) | 6 |
Offside Rear fog lamp missing |1.3.2a| | 5 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 5 |
Nearside Rear Direction indicator insecure |1.5.3b| | 5 |
Service brake: efficiency below requirements |3.7.B.7| | 5 |
Wheel alignment incorrect which adversely affects the steering |2.5.1| | 5 |
Rear Drive chain excessively loose |6.2.1d| | 5 |
Rear Roller brake test indicates excessive fluctuation of brake effort |3.3.A1d| | 5 |
Front Front position lamp does not illuminate immediately when switched on |1.1.3a| | 5 |
Exhaust markings indicating not for road use or similar wording |7.1.4| | 4 |
Offside Steering rack gaiter split |2.2.D.2d| | 4 |
Offside Rear Rear fog lamp missing |1.3.2a| | 4 |
Front Wheel has an excessively distorted bead rim. |4.2.2| | 4 |
Offside Front Direction indicators not working |1.5.1c| | 4 |
Centre Stop lamp not working |1.2.1b| | 4 |
Offside Rear Anti-roll bar linkage has excessive play in a ball joint |2.4.G.2| | 4 |
Offside Front Direction indicator incorrect colour |1.5.1b| | 4 |
Nearside Rear Shock absorber has a serious fluid leak |2.7.3| | 4 |
Horn not loud enough to be heard by another road user |1.7.3a| | 4 |
Direction indicators affected by the operation of another lamp |1.5.1c| | 4 |
Rear Wheel spoke excessively loose |4.2.1b| | 4 |
Stop lamp remains on when the brake is released |1.3.1e| | 4 |
Nearside Rear Suspension arm rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 4 |
Wheel alignment incorrect which adversely affects the handling |2.5.1| | 4 |
Riders seat insecure |6.2.1a| | 4 |
Front Wheel bearing rough when rotated (5.1.3 (b) (i)) | 4 |
Front Stop lamp not working (4.3.1 (a) (ii)) | 4 |