| Most common failures | No# failures |
|---|
| Windscreen wiper does not clear the windscreen effectively | 3 |
| Nearside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
| Offside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
| Registration plate lamp issues | 1 |
| Offside Front front brake binding |3.7.B.1| | 1 |
| Front brake excessively fluctuating | 1 |
| Rear Exhaust system not adequately supported |7.1.1| | 1 |
| Service brake is causing the steering wheel to severely pull one way |3.7.C.2| | 1 |
| Headlamp aim out of alignment | 1 |
| Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Anti-lock braking system warning lamp indicates an ABS fault | 1 |
| Brake pedal anti-slip provision incomplete |3.3.A.1b| | 1 |
| Front Headlamp not working on dipped beam |1.7.5a| | 1 |
| Nearside Front Brake lining|s| less than 1.5 mm thick |3.5.1g| | 1 |
| Offside Front Brake lining|s| less than 1.5 mm thick |3.5.1g| | 1 |
| Rear parking brake recording little or no effort | 1 |
| Offside Front Anti-roll bar linkage has excessive play in a pin/bush |2.4.G.2| | 1 |
| Parking brake: efficiency below requirements |3.7.B.7| | 1 |
| Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition |8.1.1 |a|| | 1 |
| Rear Exhaust has a major leak of exhaust gases |6.1.2 |a|| | 1 |
| Nearside Front Headlamp light intensity severely reduced |4.1.4 |a|| | 1 |
| Offside Front Headlamp light intensity severely reduced |4.1.4 |a|| | 1 |
| Nearside Front Outer Floor insecure |6.2.4 |a| |i|| | 1 |
| Offside Front Outer Floor excessively deteriorated |6.2.4 |a| |i|| | 1 |
| Nearside Front Upper Body insecure inner wing. |6.2.2 |a| |i|| | 1 |
| Emissions not tested |8.2.1.2 |d|| | 1 |
| Nearside Front Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded inner wing |2.4.A.3| | 1 |