Most common failures | No# failures |
---|
Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
Registration plate lamp issues | 2 |
Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 2 |
Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
Brakes imbalanced across an axle | 2 |
Offside Rear Braking system leaking |3.6.A.1| | 2 |
Brake pedal creeps down when held under pressure |3.3.B.1a| | 2 |
Headlamp aim out of alignment | 2 |
Offside Body or chassis has an inadequate repair, seriously affecting its strength within 30cm of the body mountings inner sill by cross member and o/s/rear suspension |6.1.B.2| | 1 |
Offside Front Ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt inner |2.2.C.1c| | 1 |
Nearside Body or chassis has an inadequate repair, seriously affecting its strength within 30cm of the body mountings inner |6.1.B.2| | 1 |
Centre Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Nearside Inner Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Nearside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Service brake efficiency less than 50% of the required value |1.2.2 |a| |ii|| | 1 |
Parking brake efficiency less than 50% of the required value |1.4.2 |a| |ii|| | 1 |
Dipswitch operation does not extinguish all main beam headlamps leaving at least one pair of dipped beam headlamps |1.7.4b| | 1 |
Nearside Rear wheel bearing rough when rotated |2.6.1| | 1 |
Rear brake binding | 1 |
Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Nearside Inner Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Inner Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Fuel cap/sealing device sealing washer deteriorated |7.2.4c| | 1 |
Nearside Front Service brake indicates brake bind |3.7.D.2a| | 1 |
Offside Front Service brake indicates brake bind |3.7.D.2a| | 1 |
Nearside Front Anti-roll bar has excessive play in a pin/bush |2.4.G.2| | 1 |
Offside Front Anti-roll bar has excessive play in a pin/bush |2.4.G.2| | 1 |
Brake hose excessively deteriorated | 1 |
Offside Rear Service brake indicates brake bind |3.7.D.2a| | 1 |
Nearside Headlamp not working on main beam |1.7.5a| | 1 |
Exhaust system not adequately supported |7.1.1| | 1 |
Offside Rear Fuel system component insecure |7.2.1| | 1 |
Rear brake application uneven | 1 |
Offside rear brake recording little or no effort |3.7.B.5a| | 1 |
Rear parking brake recording little or no effort | 1 |
Parking brake lever has no reserve travel |3.1.6b| | 1 |
Offside Front Steering system fouling |2.2.D.2a| | 1 |
Parking brake: efficiency below requirements |3.7.B.7| | 1 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Inner Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill/cross member |6.1.B.2| | 1 |
Offside Front Brake hydraulic reservoir retaining device missing |3.6.A.2d| | 1 |
Offside Front Brake pipe fouled by moving parts |3.6.B.2a| | 1 |
Nearside Rear Fuel system component insecure |7.2.1| | 1 |
Offside Front Fuel system component insecure |7.2.1| | 1 |
Horn not working |1.6.2a| | 1 |
Nearside Outer Front Steering locking device missing |2.2.C.1g| | 1 |
Nearside Inner Front Steering locking device missing |2.2.C.1g| | 1 |
Offside Inner Rear Brake pipe inadequately supported |3.6.B.1| | 1 |
Centre Rear Brake pipe inadequately clipped |3.6.B.1| | 1 |
Centre Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Offside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Nearside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Nearside Front Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Headlamp not working on main beam |1.7.5a| | 1 |
Offside Rear rear brake recording little or no effort |3.7.B.5a| | 1 |