Most common failures | No# failures |
---|
Windscreen wiper does not clear the windscreen effectively | 6 |
Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i)) | 3 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i)) | 2 |
Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 2 |
Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 2 |
Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 2 |
Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 2 |
Offside Rear Rear fog lamp not working (4.5.1 (a) (ii)) | 2 |
Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 2 |
Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 2 |
Rear fog lamp not working (4.5.1 (a) (ii)) | 2 |
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
Nearside Front Suspension component mounting prescribed area is inadequately repaired outrigger (5.3.6 (a) (i)) | 1 |
Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i)) | 1 |
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i)) | 1 |
Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
Windscreen washer not working | 1 |
Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced Outer Sill (7.1.1 (a) (i)) | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner/outer sill area (5.3.6 (a) (i)) | 1 |
Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
Exhaust has a major leak of exhaust gases back box (6.1.2 (a)) | 1 |
Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i)) | 1 |
Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sill (5.3.6 (a) (i)) | 1 |
Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i)) | 1 |
Brakes imbalanced across an axle | 1 |
Offside Front Service brake excessively binding (1.2.1 (f)) | 1 |
Front brake disc in such a condition that it is seriously weakened | 1 |
Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill inner and outer (6.1.1 (c) (i)) | 1 |
Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill inner and outer (6.1.1 (c) (i)) | 1 |
Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Inner wheel arch excessively corroded (6.1.1 (c) (i)) | 1 |
Nearside Front Brake disc significantly and obviously worn (1.1.14 (a) (i)) | 1 |
Offside Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
Nearside Rear Stop lamp(s) lens defective such that the emitted light is adversely affected (4.3.1 (b) (ii)) | 1 |
Nearside Rear Position lamp lens seriously defective (4.2.1 (b)) | 1 |
Offside Obligatory mirror does not provide a view to the rear (3.3 (c)) | 1 |
Offside Rear Seat belt buckle missing (7.1.2 (d)) | 1 |
Nearside Rear Seat belt buckle missing (7.1.2 (d)) | 1 |
Rear Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 1 |
Rear Exhaust system insecure (6.1.2 (a)) | 1 |
Rear Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b)) | 1 |
Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill leading into arch (5.3.6 (a) (i)) | 1 |
Nearside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 1 |
Rear fog lamp switch inoperative (4.5.3 (a)) | 1 |
Battery insecure and likely to cause a short circuit (4.13 (a) (ii)) | 1 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i)) | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i)) | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sills holed, has had a bad repair before thats peeling off inner sill (5.3.6 (a) (i)) | 1 |
Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill in two places. (5.3.6 (a) (i)) | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill end. (5.3.6 (a) (i)) | 1 |
Offside Rear Vehicle structure excessively corroded within 30cm of towbar mounting Cross member (6.1.6 (i) (i)) | 1 |
Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
Front Upper Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt both missing boot clips (5.3.4 (b) (ii)) | 1 |
Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
Offside Front Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i)) | 1 |
Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced crossmember (6.1.1 (c) (i)) | 1 |
Brake performance not tested due to suspension arm movement (1.2.1 (g)) | 1 |
Registration plate lamp issues | 1 |
Rear Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
Offside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
Offside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
Anti-lock braking system warning lamp indicates an ABS fault | 1 |
Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i)) | 1 |
Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i)) | 1 |
Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a) | 1 |
Front position lamp(s) not working (1.1.A.3b) | 1 |
Front Front position lamp(s) not working (1.1.A.3b) | 1 |
Offside Headlamp not working on main beam (4.1.1 (a) (ii)) | 1 |
Rear Anti-roll bar has excessive play in a pin/bush d (2.4.G.2) | 1 |
Offside Front Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a) | 1 |
Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sill (6.2.2 (d) (i)) | 1 |
Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting floor corroded (6.2.2 (d) (i)) | 1 |
Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sill (6.2.2 (d) (i)) | 1 |
Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner rear of the wheel arch (6.2.2 (d) (i)) | 1 |
Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
Offside Front Lower Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i)) | 1 |
Offside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced middle seats (7.1.1 (a) (i)) | 1 |