| Most common failures | No# failures |
|---|
| Offside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 8 |
| Nearside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 7 |
| Brake pipe excessively corroded | 7 |
| Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 6 |
| Nearside Front Direction indicator incorrect colour |1.4.A.2f| | 4 |
| Headlamp aim out of alignment | 4 |
| Parking brake: efficiency below requirements |3.7.B.7| | 4 |
| Offside Front constant velocity joint gaiter split |2.5.C.1a| | 3 |
| Registration plate lamp issues | 3 |
| Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
| Rear parking brake recording little or no effort | 3 |
| Rear brake binding | 3 |
| Horn not working |1.6.2a| | 2 |
| Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement |7.2.4b| | 2 |
| Rear Brake load sensing valve linkage seized |3.6.E.3| | 2 |
| Offside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 2 |
| Nearside Rear Upper Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Nearside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 2 |
| Offside Rear fog lamp not working |1.3.2b| | 2 |
| Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 2 |
| Nearside Front position lamp|s| not working |1.1.A.3b| | 2 |
| Offside Front position lamp|s| not working |1.1.A.3b| | 2 |
| Brake load sensing valve linkage seized |3.6.E.3| | 2 |
| Brakes imbalanced across an axle | 2 |
| Offside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 2 |
| Offside Rear Direction indicator not working |1.4.A.2c| | 2 |
| Hazard warning tell tale not working correctly |1.4.B.1e| | 2 |
| Offside Rear Rear fog lamp not working |1.3.2b| | 2 |
| Offside Stop lamp not working |1.2.1b| | 2 |
| Fuel system component leaking |7.2.3| | 2 |
| Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
| Offside Steering system has excessive free play detected at the steering wheel |steering rack fitted| |2.2.A.1b| | 1 |
| Indicator tell tale inoperative |1.4.A.2a| | 1 |
| Windscreen wiper does not clear the windscreen effectively | 1 |
| Nearside Front Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
| Offside Front Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
| Horn not loud enough to be heard by another road user |1.6.2b| | 1 |
| Nearside Rear Rear wheel bearing rough when rotated |2.6.1| | 1 |
| Nearside Rear Shock absorber has negligible damping effect |2.7.5| | 1 |
| Offside Rear Shock absorber has negligible damping effect |2.7.5| | 1 |
| Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Offside Front Bonded suspension unit deteriorated and cannot function as intended |2.4.F.3| | 1 |
| Offside Rear Upper Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Front Steering rack gaiter split |2.2.D.2d| | 1 |
| Fuel hose leaking |7.2.3| | 1 |
| Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Emissions not tested |7.0| | 1 |
| Rear Rear fog lamp not working |1.3.2b| | 1 |
| Nearside Rear Stop lamp not working |1.2.1b| | 1 |
| Exhaust emits an excessive level of metered smoke for a non-turbo charged engine |7.4.B.3b| | 1 |
| Nearside Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Service brake: efficiency below requirements |3.7.B.7| | 1 |
| Front Windscreen wiper blade deteriorated |8.2.2| | 1 |
| Rear Mechanical brake component has restricted free movement | 1 |
| Offside Rear Mechanical brake component securing device missing |3.5.1i| | 1 |
| Offside rear brake recording little or no effort |3.7.B.5a| | 1 |
| Brake master cylinder fluid level below minimum level |3.6.G.1e| | 1 |
| Offside Rear Brake actuating linkage mounting prescribed area is excessively corroded |3.3.A.2| | 1 |
| Offside Front constant velocity joint gaiter insecurely mounted to its housing |2.5.C.1a| | 1 |
| Brake load sensing valve linkage defective and function impaired |3.6.E.3| | 1 |
| Nearside Front drive shaft coupling flexible rubber or fabric coupling fouling any other part of the vehicle |2.5.C.1e| | 1 |
| Nearside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
| Offside Parking brake: efficiency below requirements |3.7.B.7| | 1 |
| Hazard warning switch faulty |1.4.B.1d| | 1 |
| Offside front brake binding |3.7.B.1| | 1 |
| Seat belt anchorage prescribed area is inadequately repaired |5.2.6| | 1 |
| Nearside Front front brake binding |3.7.B.1| | 1 |
| Offside Front front brake binding |3.7.B.1| | 1 |
| Offside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
| Offside Front Direction indicator incorrect colour |1.4.A.2f| | 1 |
| Nearside Front Bonded suspension unit bonding failed and part of unit is likely to become displaced |2.4.F.2| | 1 |
| Windscreen has damage | 1 |
| Nearside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
| Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
| Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
| Nearside Headlamp not working on main beam |1.7.5a| | 1 |
| Offside Headlamp not working on main beam |1.7.5a| | 1 |
| Nearside Side repeater not working |1.4.A.2c| | 1 |
| Offside Side repeater not working |1.4.A.2c| | 1 |
| Nearside Front Direction indicator not working |1.4.A.2c| | 1 |
| Offside Front Direction indicator not working |1.4.A.2c| | 1 |
| Nearside Rear Direction indicator not working |1.4.A.2c| | 1 |
| Nearside Front Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
| Offside Front Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
| Offside Rear Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
| Nearside Rear Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
| Nearside Front Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f| | 1 |
| Offside Front Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f| | 1 |
| Offside Rear Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f| | 1 |
| Nearside Rear Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f| | 1 |
| Nearside Stop lamp not working |1.2.1b| | 1 |
| Nearside Front Direction indicators incorrect colour |1.4.A.2f| | 1 |
| Offside Front Direction indicators incorrect colour |1.4.A.2f| | 1 |
| Rear Brake pipe inadequately clipped |3.6.B.1| | 1 |
| Offside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
| Nearside Rear An item not tested |Manual| | 1 |
| Outer Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Rear Stop lamp adversely affected by the operation of another lamp |1.2.1f| | 1 |
| Front brake application uneven | 1 |
| Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Centre Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Rear wheel bearing rough when rotated |2.6.1| | 1 |
| Offside Rear wheel bearing rough when rotated |2.6.1| | 1 |