Most common failures | No# failures |
---|
Headlamp aim out of alignment | 4 |
Registration plate lamp issues | 3 |
Rear brake binding | 3 |
Rear parking brake recording little or no effort | 3 |
Nearside rear brake recording little or no effort |3.7.B.5a| | 2 |
Service brake: efficiency below requirements |3.7.B.7| | 2 |
Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a)) | 1 |
Power steering fluid level below minimum |2.3.1| | 1 |
Parking brake lever is impeded in its travel |3.1.6c| | 1 |
Electrical wiring insecure |1.9.2a| | 1 |
Nearside Side repeater not working |1.4.A.2c| | 1 |
Battery insecure |1.9.1| | 1 |
Nearside Front Shock absorber has a serious fluid leak |2.7.3| | 1 |
Power steering pump leaking from a failed component |2.3.3b| | 1 |
Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Nearside Axle king pin has excessive play in pin and/or bush adversely affecting the steering |2.5.A.3a| | 1 |
Offside Axle king pin has excessive play in pin and/or bush adversely affecting the steering |2.5.A.3a| | 1 |
Offside rear brake recording little or no effort |3.7.B.5a| | 1 |
Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Parking brake: efficiency below requirements |3.7.B.7| | 1 |
Brakes imbalanced across an axle | 1 |
Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 1 |
Brake pipe excessively corroded | 1 |
Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Power steering component|s| leaking |2.3.3b| | 1 |
Centre Exhaust has a major leak of exhaust gases |7.1.2| | 1 |