| Most common failures | No# failures |
|---|
| Registration plate issues | 4 |
| Brake pipe excessively corroded | 4 |
| Offside Front Headlamp not working on dipped beam |1.7.5a| | 2 |
| Windscreen wiper does not clear the windscreen effectively | 2 |
| Registration plate lamp issues | 2 |
| Offside Front Track rod end ball joint has excessive play |2.2.B.1f| | 2 |
| Windscreen has damage | 2 |
| Horn not working |1.6.2a| | 2 |
| Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i)) | 1 |
| Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i)) | 1 |
| Offside Front Body panel insecure wing (6.2.1 (a) (i)) | 1 |
| Offside Front Inner Brake master cylinder/servo mounting prescribed area is excessively corroded wing (1.1.21 (e) (i)) | 1 |
| Nearside Front Headlamp are incorrectly positioned high (4.1.4 (a)) | 1 |
| Offside Front Headlamp are incorrectly positioned low (4.1.4 (a)) | 1 |
| Nearside Front Side repeater not working (4.4.1 (a) (ii)) | 1 |
| Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Offside Front Floor excessively deteriorated side step (6.2.4 (a) (i)) | 1 |
| Offside Front Drivers door cannot be opened from outside the vehicle (6.2.3 (a)) | 1 |
| Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i)) | 1 |
| Rear Brake load sensing valve seized but ABS functioning (1.1.17 (c) (i)) | 1 |
| Oil leaking excessively from engine (8.4.1 (a) (i)) | 1 |
| Nearside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wing holed and corroded within 30cm of sub frame mount (5.3.6 (a) (i)) | 1 |
| Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wing holed and corroded within 30cm of sub frame mounting (5.3.6 (a) (i)) | 1 |
| Offside Front Headlamp not working on main beam |1.7.5a| | 1 |
| Nearside Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
| Nearside Rear Seat belt cut sufficient to obstruct correct operation of the belt |5.2.2a| | 1 |
| Nearside Front Lower Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
| Offside Leaf spring main leaf fractured (5.3.1 (b) (ii)) | 1 |
| Offside Rear fog lamp lens defective such that emitted light is adversely affected (4.5.1 (b) (ii)) | 1 |
| Windscreen washer not working | 1 |
| Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Upper Front position lamp|s| not working both |1.1.A.3b| | 1 |
| Offside Front Body has a sharp edge caused by corrosion wing |6.1.C.1| | 1 |
| Front brake disc in such a condition that it is seriously weakened | 1 |
| Offside Front brake caliper leaking |3.6.A.1| | 1 |
| Nearside Front Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
| Front Anti-roll bar rubber bush deteriorated resulting in excessive movement d bushes |2.4.G.2| | 1 |
| Nearside Rear Anti-roll bar linkage has excessive play in a pin/bush |2.4.G.2| | 1 |
| Rear brake binding | 1 |
| Service brake: efficiency below requirements |3.7.C.1a| | 1 |
| Parking brake: efficiency below requirements |3.7.C.1b| | 1 |
| Brakes imbalanced across an axle | 1 |
| Parking brake: efficiency below requirements |3.7.B.7| | 1 |
| Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Stop lamp not working |1.2.1b| | 1 |
| Brake load sensing valve seized |3.6.E.3| | 1 |
| Offside Front Body has a sharp edge caused by damage |6.1.C.1| | 1 |
| Rear Seat belt locking mechanism does not secure or release |5.2.5a| | 1 |
| Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |