Most common failures | No# failures |
---|
Brake hose excessively deteriorated | 5 |
Rear parking brake recording little or no effort | 3 |
Parking brake: efficiency below requirements |3.7.B.7| | 2 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 2 |
Rear fog lamp tell tale not working |1.3.1b| | 2 |
Rear brake application uneven | 2 |
Offside Stop lamp not working |1.2.1b| | 2 |
Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 2 |
Nearside Side repeater not working |1.4.A.2c| | 1 |
Nearside Rear Leaf spring anchor bracket corroded and seriously weakened |2.4.B.6d| | 1 |
Offside rear brake recording little or no effort |3.7.B.5a| | 1 |
Brakes imbalanced across an axle | 1 |
Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced crossmember (6.1.1 (c) (i)) | 1 |
Nearside Front Upper Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced innerwing (6.1.1 (c) (i)) | 1 |
Nearside Front Lower Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill to inner wheel arch (6.1.1 (c) (i)) | 1 |
Offside Front Lower Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill to inner wheel arch (6.1.1 (c) (i)) | 1 |
Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced lower boot floor wells both sides to inner wheelarches (6.1.1 (c) (i)) | 1 |
Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced near rear spring hanger (6.1.1 (c) (i)) | 1 |
Hazard warning switch insecure |1.4.B.1d| | 1 |
Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Offside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Offside Rear Statutory seat belt missing |5.1.1| | 1 |
Fuel pipe insecure |7.2.1| | 1 |
Nearside Rear Brake pipe inadequately clipped |3.6.B.1| | 1 |
Nearside Rear Brake pipe fouled by moving parts |3.6.B.2a| | 1 |
Offside Front Steering rack gaiter split |2.2.D.2d| | 1 |
Nearside Front brake caliper securing device missing |3.5.1j| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Brake clevis joint inappropriately repaired |3.5.1n| | 1 |
Headlamp aim out of alignment | 1 |
Nearside Front Seat belt retracting mechanism defective |5.2.5b| | 1 |
Nearside Rear Seat belt retracting mechanism defective |5.2.5b| | 1 |
Suspension component mounting prescribed area excessively corroded significantly reducing structural strength welding |5.3.6 |a| |i|| | 1 |
Centre Exhaust system not adequately supported |7.1.1| | 1 |
Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Rear brake binding | 1 |
Rear Body has a projection caused by damage |6.1.C.1| | 1 |
Front Body has a projection caused by damage |6.1.C.1| | 1 |
Registration plate issues | 1 |
Offside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Rear fog lamp not working |1.3.2b| | 1 |
Nearside Front Windscreen wiper blade deteriorated |8.2.2| | 1 |
Offside Brake cable has wires broken and is significantly weakened |3.5.1b| | 1 |
Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings near rear leaf spring |6.1.B.2| | 1 |
Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner sill back 2 places |6.1.B.2| | 1 |
Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings near brake line flexi |6.1.B.2| | 1 |
Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner wheel arch going on to floor also bottom of inner wing |6.1.B.2| | 1 |
Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner wheel arch on to floor also botto of wing on inner side |6.1.B.2| | 1 |
Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings near anti roll bar anchor point |6.1.B.2| | 1 |
Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings right at back near leaf spring bolt point |6.1.B.2| | 1 |
Rear Exhaust has a major leak of exhaust gases back box snapped |7.1.2| | 1 |
Exhaust engine idle speed too high |7.3.A.2a| | 1 |
Suspension component mounting prescribed area is excessively corroded front and rear |2.4.A.3| | 1 |
Mechanical brake component has restricted free movement | 1 |