| Most common failures | No# failures |
|---|
| Windscreen wiper does not clear the windscreen effectively | 2 |
| Rear fog lamp not working |1.3.2b| | 2 |
| Registration plate lamp issues | 2 |
| Nearside Front Body has a sharp edge caused by corrosion |6.1.C.1| | 2 |
| Headlamp aim out of alignment | 2 |
| Offside Rear Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
| Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer sill (5.3.6 (a) (i)) | 1 |
| Brake pipe excessively corroded | 1 |
| Offside Front Service brake excessively binding (1.2.1 (f)) | 1 |
| Nearside Rear Parking brake inoperative on one side (1.4.1 (a)) | 1 |
| Parking brake: efficiency below requirements |3.7.B.7| | 1 |
| Exhaust emits an excessive level of metered smoke for a turbo charged engine |7.4.B.3b| | 1 |
| Rear fog lamp not working |4.5.1 |a| |ii|| | 1 |
| Oil leaking excessively from engine Engine covered |8.4.1 |a| |i|| | 1 |
| Nearside Front Service brake excessively binding |1.2.1 |f|| | 1 |
| Nearside Rear Service brake excessively binding |1.2.1 |f|| | 1 |
| Offside Rear Service brake excessively binding |1.2.1 |f|| | 1 |
| Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Cross member x2 |5.3.6 |a| |i|| | 1 |
| Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength crossmember |5.3.6 |a| |i|| | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill |5.3.6 |a| |i|| | 1 |
| Rear parking brake recording little or no effort | 1 |
| Rear Exhaust has a major leak of exhaust gases Section |6.1.2 |a|| | 1 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded inner sill |2.4.A.3| | 1 |
| Offside Rear Anti-roll bar linkage has excessive play in a pin/bearing |2.4.G.2| | 1 |
| Nearside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Nearside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement D-Bush |2.4.G.2| | 1 |
| Offside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement D-Bush |2.4.G.2| | 1 |
| Rear fog lamp switch missing |1.3.1a| | 1 |
| Offside Front Wheel nut|s| loose |4.2.A.1e| | 1 |
| Nearside Side repeater not working |1.4.A.2c| | 1 |
| Offside Front Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e| | 1 |
| Nearside Front Windscreen wiper blade deteriorated |8.2.2| | 1 |
| Offside Front Windscreen wiper blade deteriorated |8.2.2| | 1 |
| Prop shaft bearing excessively worn front and rear deteriorated (6.1.7 (b) (i)) | 1 |
| Rear Lower Shock absorber has an excessively worn bush |2.7.4| | 1 |
| Emissions not tested |7.0| | 1 |
| Parking brake lever has excessive side play in the pivot and may disengage |3.1.4a| | 1 |
| Stop lamp(s) all not working (4.3.1 (a) (iii)) | 1 |
| Nearside Front Body panel corroded and likely to cause injury wheel arch (6.2.1 (a) (i)) | 1 |
| Brakes imbalanced across an axle | 1 |
| Offside Front Lower Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
| Rear brake application uneven | 1 |
| All direction indicators not working (4.4.1 (a) (ii)) | 1 |