>

MOT History from tests of petrol FORD BONGOs year 1999

Review the list of common FORD BONGO failures below or to perform a specific mot history check on your FORD then use our popular KnowYourCar service

mot history
Pass percent:48.42%
(The average a petrol FORD BONGO year 1999 passes without issue)
Based on:95 MOT Tests
Most common failuresNo# failures
Windscreen wiper does not clear the windscreen effectively14
Rear fog lamp not working |1.3.2b|5
Exhaust carbon monoxide content after 2nd fast idle exceeds default limits |8.2.1.2 |b||4
Rear fog lamp switch missing |1.3.1a|3
Registration plate lamp issues3
Battery insecure |1.9.1|3
Exhaust emissions Lambda reading after 2nd fast idle outside specified limits |7.3.D.3|3
Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))3
Exhaust Lambda reading after 2nd fast idle outside specified limits |8.2.1.2 |c||3
Rear fog lamp missing |1.3.2a|2
Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))2
Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))2
Front brake excessively fluctuating2
Exhaust has a major leak of exhaust gases (6.1.2 (a))2
Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))2
Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b|2
Offside Headlamp aim beam image obviously incorrect |1.8.A.1b|2
Exhaust has a major leak of exhaust gases |7.1.2|2
Offside Rear fog lamp not working |1.3.2b|2
Nearside Stop lamp not working |1.2.1b|2
Exhaust carbon monoxide content at idle exceeds default limits |8.2.1.2 |b||2
Headlamp aim out of alignment2
Offside Rear fog lamp does not emit a steady red light (4.5.4 (a))2
Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3|2
Rear fog lamp tell tale missing |1.3.1b|2
Windscreen has damage2
Rear Passenger`s seat insecure |6.2.A.1|1
Nearside Position lamp showing white light to the rear |4.2.3 |a| |ii||1
Nearside Stop lamp|s| showing white light to the rear |4.3.3 |a| |ii||1
Parking brake efficiency less than 50% of the required value |1.4.2 |a| |ii||1
Offside Stop lamp(s) not working (4.3.1 (a) (ii))1
Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))1
Offside Rear fog lamp emits a light other than red |1.3.2e|1
Electrical wiring insecure negative battery terminal |1.9.2a|1
Nearside rear brake excessively fluctuating |3.7.B.3|1
Offside rear brake excessively fluctuating |3.7.B.3|1
Fuel cap/sealing device ineffective |6.1.3 |b| |i||1
Nearside Headlamp aim so that beam "kick up" is not visible on the screen |4.1.2 |a||1
Offside Headlamp aim so that beam "kick up" is not visible on the screen |4.1.2 |a||1
Offside Stop lamp|s| not working |4.3.1 |a| |ii||1
Offside Rear fog lamp does not emit a steady red light |4.5.4 |a||1
Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt |5.3.4 |b| |ii||1
Nearside Rear Position lamp showing white light to the rear (4.2.3 (a) (ii))1
Nearside Stop lamp(s) not working (4.3.1 (a) (ii))1
Horn not loud enough to be heard by another road user |1.6.2b|1
Central Upper Stop lamp has less than 50% of the light sources illuminating |1.2.1b|1
Brakes imbalanced across an axle1
Nearside Rear Service brake excessively binding |1.2.1 |f||1
Rear fog lamp does not face the rear |1.3.2a|1
Offside Rear position lamp|s| excessively damaged so that it is not visible from a reasonable distance |1.1.A.3d|1
Nearside Headlamp has a product on the lens so that the light output is severely reduced |1.7.5a|1
Offside Headlamp has a product on the lens so that the light output is severely reduced |1.7.5a|1
Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e|1
Nearside Steering rack gaiter split |2.2.D.2d|1
Nearside Rear Direction indicator not working |1.4.A.2c|1
Offside Rear Rear fog lamp insecure |1.3.2a|1
Nearside Front Bumper insecure (6.1.4 (a) (i))1
Central Front Lower Integral body structure is fractured and structural rigidity is significantly reduced cross member under radiator (6.1.1 (a) (i))1
Offside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))1
Brake performance not tested due to rear pads low (1.2.1 (g))1
Nearside Rear Rear position lamp|s| incorrect colour damaged and showing white light |1.1.A.3e|1
Nearside Rear Direction indicator incorrect colour damaged and showing white light |1.4.A.2f|1
Brake performance not tested under panel hanging to low stopping roller test |1.2.1 |g||1
Rear Stop lamp|s| all not working |4.3.1 |a| |iii||1
Nearside Front Position lamp light intensity significantly reduced |4.2.3 |a| |ii||1
Nearside Front Headlamp has a product on the lens so that the light output is severely reduced |4.1.4 |b||1
Offside Front Battery insecure and likely to cause a short circuit |4.13 |a| |ii||1
Nearside Rear Position lamp not working |4.2.1 |a| |ii||1
Exhaust hydrocarbon content after 2nd fast idle exceeds default limits |8.2.1.2 |b||1
Exhaust emissions likely to be affected by an exhaust leak |8.2.1.1 |b||1
Central Rear Statutory seat belt missing |5.1.1|1
Offside Front position lamp|s| incorrect colour |1.1.A.3e|1
Offside Rear Rear fog lamp does not emit a steady red light |4.5.4 |a||1
Nearside Front Headlamp aim so that beam "kick up" is not visible on the screen |4.1.2 |a||1
Nearside Front Anti-roll bar linkage has excessive play in a ball joint |2.4.G.2|1
Offside Front Anti-roll bar linkage has excessive play in a ball joint |2.4.G.2|1
Nearside Rear Anti-roll bar linkage has excessive play in a pin/bush |2.4.G.2|1
Offside Rear Anti-roll bar linkage has excessive play in a pin/bush |2.4.G.2|1
Nearside Rear Stop lamp not working |1.2.1b|1
Offside Front Headlamp aim beam image obviously incorrect |1.8.A.1b|1
Nearside Rear Seat belt has a cut which has significantly weakened the webbing |5.2.2a|1
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))1
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))1
Emissions not tested |7.0|1
Nearside Front Direction indicator not working |1.4.A.2c|1
Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))1
Nearside Headlamp not working on main beam (4.1.1 (a) (ii))1
Central Exhaust has a major leak of exhaust gases (6.1.2 (a))1
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))1
Nearside Side repeater not working |1.4.A.2c|1
Rear fog lamp emits a light other than red |1.3.2e|1
Nearside Front Lower Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2|1
Nearside Headlamp not working on main beam |1.7.5a|1
Offside Front Anti-roll bar ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt drop link |2.4.G.2|1
Nearside Front Headlamp not working on main beam |1.7.5a|1
Offside Stop lamp not working |1.2.1b|1
Offside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2|1
Offside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2|1
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength TWO PLACES AS MARKED (5.3.6 (a) (i))1
Exhaust emissions carbon monoxide content at idle excessive |7.3.D.4|1
Rear fog lamp missing |4.5.1 |a| |ii||1
Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer`s specified limits |8.2.1.2 |a||1
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength x two |5.3.6 |a| |i||1
Fluid leaking continuously posing a serious risk to road safety |8.4.1 |a| |ii||1
Offside Rear Anti-roll bar attachment bracket/mounting fractured |2.4.G.1|1
Offside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2|1
Nearside Front Body component damaged and likely to cause injury door |6.2.1 |a| |i||1
Offside Front Anti-roll bar linkage pin or bush excessively worn link arm |5.3.4 |a| |i||1
Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced out rigger |6.1.1 |c| |i||1
Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced out rigger |6.1.1 |c| |i||1
Nearside Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill |6.1.1 |c| |i||1
Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced out rigger |6.1.1 |c| |i||1
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill |5.3.6 |a| |i||1
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill |5.3.6 |a| |i||1
Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))1
Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))1
Nearside Front Inner Seat belt anchorage prescribed area strength or continuity significantly reduced Sill. (7.1.1 (a) (i))1
Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))1
Nearside Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))1
Offside Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))1
Nearside Seat belt anchorage prescribed area is excessively corroded outer sill |5.2.6|1
Nearside Seat belt anchorage prescribed area is excessively corroded inner sill [as marked] |5.2.6|1
Nearside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2|1
Rear brake binding1
Offside Suspension component mounting prescribed area is excessively corroded sill outer |2.4.A.3|1
Offside Suspension component mounting prescribed area is excessively corroded sill inner |2.4.A.3|1
Rear fog lamp not working |4.5.1 |a| |ii||1
Offside Rear Rear fog lamp not working |1.3.2b|1

We get to these numbers by trawling through over 1 billion MOT test results since 2004 and crunched the numbers. We remove anything to do with Tyres, as they are model independent and group together common non-model specific issues. We are trying to get to a picture of what models have what issues.

Please note: We take the data from the DVSA. This data is raw and can contain typos and spelling mistakes that garages may have entered while recording a MOT result. Specifically miss-match on names of models and makes. We are constantly cleaning the data so bear with the odd issue.

Got suggestions? We’re improving this section all the time. If you have any suggestions, please let us know.

Find us on Facebook

© KnowYourCar™ 2019. All rights reserved
Except where otherwise noted, content on our MOT statistics pages are licensed under a Creative Commons Attribution 4.0 International license.
You are free to redistribute the material in any medium or format as long as credit is given to KnowYourCar

WARNING: We have placed hidden watermarks in our data. We will take action against our data being used outside of these terms.

MOT Data licensed under the Open Government Licence v3.0

By using our site you are agreeing to our terms and conditions
Terms & Conditions  Privacy Policy