Most common failures | No# failures |
---|
Brake pipe excessively corroded | 12 |
Windscreen wiper does not clear the windscreen effectively | 9 |
Registration plate lamp issues | 9 |
Headlamp aim out of alignment | 4 |
Horn not working |1.6.2a| | 3 |
Horn not working (7.7 (a) (ii)) | 3 |
Offside Stop lamp not working |1.2.1b| | 2 |
Centre Exhaust system not adequately supported |7.1.1| | 2 |
Offside Front position lamp|s| not working |1.1.A.3b| | 2 |
Offside Rear fog lamp not working |1.3.2b| | 2 |
Offside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Offside Front Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
Nearside Rear Brake pipe kinked |3.6.B.2b| | 1 |
Offside Rear Brake pipe kinked |3.6.B.2b| | 1 |
Offside Rear Outline marker lamp not working (4.2.1 (a) (ii)) | 1 |
Offside Front Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
Nearside Front Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength front mount (5.3.6 (a) (i)) | 1 |
Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength rear mount (5.3.6 (a) (i)) | 1 |
Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength rear mount (5.3.6 (a) (i)) | 1 |
Offside Front Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
Nearside Front Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
Brake pipe leaking on an air braking system front to rear (1.1.11 (b) (i)) | 1 |
Fuel pipe insecure (6.1.3 (a) (i)) | 1 |
Brake load sensing valve seized but ABS functioning (1.1.17 (c) (i)) | 1 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
Brake performance not tested (1.2.1 (g)) | 1 |
Exhaust has a major leak of exhaust gases first pipe |7.1.2| | 1 |
Offside Rear Suspension spring mounting prescribed area is excessively corroded small hole frontmost spring mount area on crossmember |2.4.A.3| | 1 |
Offside Front Upper Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength upper shock absorber mount at inner chassis |5.3.6 |a| |i|| | 1 |
Nearside Headlamp light intensity severely reduced (4.1.4 (a)) | 1 |
Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Registration plate issues | 1 |
Nearside Front Front wheel bearing has excessive play |2.5.A.3c| | 1 |
Offside Front Front constant velocity joint gaiter insecurely mounted to its housing |2.5.C.1a| | 1 |
Offside Front Direction indicator not working (4.4.1 (a) (ii)) | 1 |
Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
Central Exhaust system insecure x3 rubber rings |6.1.2 |a|| | 1 |
Brake load sensing valve linkage defective and function impaired |1.1.17 |a|| | 1 |
Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt |6.1.7 |g| |ii|| | 1 |
Nearside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Offside Upper Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt |6.1.7 |g| |ii|| | 1 |
Offside Front Wheel bearing has excessive play |5.1.3 |a| |i|| | 1 |
Power steering component fouling clutch cable cable tied to steering column (2.1.5 (e) (i)) | 1 |
Nearside Front Headlamp aim beam image kick up to the offside |1.8| | 1 |
Offside Rear Headlamp aim beam image kick up to the offside |1.8| | 1 |
Offside Outline marker lamp not working |4.2.1 |a|| | 1 |
Nearside Outline marker lamp missing |4.2.1 |a|| | 1 |
Brake load sensing valve linkage seized |3.6.E.3| | 1 |
Battery insecure and likely to fall from carrier (4.13 (a) (ii)) | 1 |
Nearside Headlamp aim beam image kick up to the offside |1.8| | 1 |
Offside Headlamp aim beam image kick up to the offside |1.8| | 1 |
Rear brake binding | 1 |
Battery insecure |1.9.1| | 1 |
Stop lamp has less than 50% of the light sources illuminating |1.2.1b| | 1 |
Exhaust system insecure rubber mounts missing and excessively perished |6.1.2 |a|| | 1 |
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing as marked |5.3.6 |a| |i|| | 1 |
Rear Brake load sensing valve seized |3.6.E.3| | 1 |
Offside Front Lower Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Rear brake application uneven | 1 |
Front Exhaust system not adequately supported |7.1.1| | 1 |
Offside Front Direction indicator not working |1.4.A.2c| | 1 |
Offside Rear Direction indicator not working |1.4.A.2c| | 1 |
Offside Hazard warning lamps inoperative |1.4.B.1b| | 1 |
Offside Outline marker lamp not working (4.2.1 (a) (ii)) | 1 |
Central Stop lamp(s) light intensity significantly reduced (4.3.3 (a) (ii)) | 1 |
Offside Front Brake prescribed area is excessively corroded Inner wheel arch (1.1.21 (e) (i)) | 1 |
Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill (5.3.6 (a) (i)) | 1 |
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill (5.3.6 (a) (i)) | 1 |
Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 1 |
Brake hose damaged | 1 |
Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Under step. (6.1.1 (c) (i)) | 1 |
Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Under step. (6.1.1 (c) (i)) | 1 |
Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Front X member. (6.1.1 (c) (i)) | 1 |
Offside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Offside Rear Stop lamp not working |1.2.1b| | 1 |
Offside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Rear Stop lamp not working |1.2.1b| | 1 |