Most common failures | No# failures |
---|
Horn not working |1.6.2a| | 4 |
Headlamp aim out of alignment | 3 |
Windscreen wiper does not clear the windscreen effectively | 3 |
Rear parking brake recording little or no effort | 2 |
Registration plate lamp issues | 2 |
Brake pipe excessively corroded | 2 |
Rear brake binding | 2 |
Nearside Front Front wheel bearing has excessive play |2.5.A.3c| | 1 |
Rear Brake cable insecure | 1 |
Front brake application uneven | 1 |
Rear Rear fog lamp emits a light other than red |1.3.2e| | 1 |
Front Battery insecure |1.9.1| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Centre Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Nearside Rear Wheel bolt|s| missing |4.2.A.1e| | 1 |
Parking brake: efficiency below requirements |3.7.B.7| | 1 |
Headlamp aim beam image kick up to the offside |1.8| | 1 |
Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Horn not loud enough to be heard by another road user |1.6.2b| | 1 |
Direction indicators incorrect colour |1.4.A.2f| | 1 |
Nearside Stop lamp adversely affected by the operation of another lamp |1.2.1f| | 1 |
Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e| | 1 |
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength upper wheel arch |5.3.6 |a| |i|| | 1 |
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength lower wheel arch |5.3.6 |a| |i|| | 1 |
Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch |5.3.6 |a| |i|| | 1 |
Offside Rear Service brake lagging in operation |1.2.1 |d|| | 1 |
Offside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Front Subframe mounting prescribed area is excessively corroded jacking point area marked yellow |2.4.A.3| | 1 |
Offside Front Lower Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i)) | 1 |
Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i)) | 1 |
Offside Front Position lamp not working (4.2.1 (a)) | 1 |
Offside Front Side repeater not working (4.4.1 (a) (ii)) | 1 |
Offside Front Direction indicator incorrect colour (4.4.3 (a)) | 1 |
Exhaust has a major leak of exhaust gases front pipe to centre section (6.1.2 (a)) | 1 |
Battery insecure and likely to cause a short circuit (4.13 (a) (ii)) | 1 |
Nearside Rear Position lamp adversely affected by the operation of another lamp dim and flashing with indicator (4.2.3 (c)) | 1 |
Offside Rear Position lamp adversely affected by the operation of another lamp dim and flashing with indicator (4.2.3 (c)) | 1 |
Nearside Rear Stop lamp(s) showing white light to the rear (4.3.3 (a) (ii)) | 1 |
Nearside Rear Stop lamp(s) adversely affected by the operation of another lamp dim and flashing with indicator (4.3.3 (b)) | 1 |
Offside Seat belt anchorage prescribed area strength or continuity significantly reduced front inner sill (7.1.1 (a) (i)) | 1 |
Exhaust system not adequately supported rubbers x4 (7.1.1) | 1 |
Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced under wheel arch marked yellow (7.1.1 (a) (i)) | 1 |
Offside Front Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength on chassis near subframe mount bolt marked yellow (5.3.6 (a) (i)) | 1 |
Exhaust emissions exceed manufacturers specified limit (8.2.2.2 (a)) | 1 |
Nearside Front Headlamp aim projected beam image is obviously incorrect no pattern (4.1.2 (c)) | 1 |
Offside Front Headlamp aim projected beam image is obviously incorrect no pattern (4.1.2 (c)) | 1 |
Horn not working (7.7 (a)) | 1 |
Offside Front Service brake excessively binding (1.2.1 (f)) | 1 |
Offside Front Service brake lagging in operation (1.2.1 (d)) | 1 |