>

MOT History from tests of petrol FIAT BRAVAs year 2008

Review the list of common FIAT BRAVA failures below or to perform a specific mot history check on your FIAT then use our popular KnowYourCar service

mot history
Pass percent:56.00%
(The average a petrol FIAT BRAVA year 2008 passes without issue)
Based on:100 MOT Tests
Most common failuresNo# failures
Headlamp aim out of alignment9
Windscreen wiper does not clear the windscreen effectively4
Registration plate lamp issues3
Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))3
Parking brake: efficiency below requirements |3.7.B.7|2
Windscreen washer not working 2
Brakes imbalanced across an axle2
Nearside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced Sill (7.1.1 (a) (i))2
Offside Rear Stop lamp not working |1.2.1b|2
Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))2
Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a))2
Nearside Rear coil spring broken |2.4.C.1a|2
Rear brake binding2
Front Exhaust has a major leak of exhaust gases (6.1.2 (a))2
Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))1
Nearside Rear Service brake excessively binding Signs of over heating to the disc and dads (1.2.1 (f))1
Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii))1
Nearside Stop lamp not working |1.2.1b|1
Offside Headlamp not working on dipped beam |1.7.5a|1
Nearside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2|1
Offside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2|1
Emissions not tested |8.2.1.2 |d||1
Sound deadening material likely to become detached |8.1.1 |b| |ii||1
Brake cable insecure |1.1.15 |c||1
Nearside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i))1
Offside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i))1
Offside Front Outer Track rod end ball joint has excessive play (2.1.3 (b) (i))1
Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))1
Brake hydraulic reservoir fluid level below minimum level |3.6.G.1b|1
Registration plate issues1
Offside Side repeater not working |4.4.1 |a| |ii||1
Offside Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt |6.1.7 |g| |ii||1
Anti-lock braking system warning lamp indicates an ABS fault1
Nearside Stop lamp(s) not working (4.3.1 (a) (ii))1
Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))1
Nearside Front Outer Track rod end ball joint has excessive play (2.1.3 (b) (i))1
Rear Exhaust system insecure (6.1.2 (a))1
Nearside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a|1
Nearside Front Front position lamp|s| not working |1.1.A.3b|1
Nearside Rear Rear position lamp|s| not working |1.1.A.3b|1
Front Exhaust has a major leak of exhaust gases |7.1.2|1
Rear Exhaust system not adequately supported |7.1.1|1
Offside Front Front wheel bearing rough when rotated |2.5.A.2|1
Emissions not tested |7.4.B.1|1
Nearside Rear Stop lamp not working |1.2.1b|1
Headlamp aim projected beam image is obviously incorrect Both lamp units frosted over - no beam pattern. (4.1.2 (c))1
Exhaust has a major leak of exhaust gases back box (6.1.2 (a))1
Headlamp aim unable to be tested Both. no pattern. (4.1.2 (b))1
Offside Rear Axle swivel pins and bushes swivel pin and/or bush excessively worn rubber come away (5.1.2 (b) (i))1
coil spring broken nearside front |2.4.C.1a|1
coil spring broken offside front |2.4.C.1a|1
Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a))1
Offside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2|1
Offside Rear fog lamp not working |1.3.2b|1
Nearside Front Anti-roll bar linkage cracked |2.4.G.1|1
Offside Rear coil spring broken |2.4.C.1a|1
Rear parking brake recording little or no effort1
Front brake disc in such a condition that it is seriously weakened1
Rear brake disc in such a condition that it is seriously weakened1
Rear Exhaust system not adequately supported exhaust bracket broken |7.1.1|1
Service brake: efficiency below requirements |3.7.B.7|1
Rear fog lamp not working (4.5.1 (a) (ii))1
Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))1
Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))1
Offside Front Position lamp not working (4.2.1 (a) (ii))1
Nearside Front Anti-roll bar ball joint excessively worn droplink (5.3.4 (a) (i))1
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i))1
Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))1
Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))1
Anti-roll bar ball joint likely to become detached both play |5.3.4 |a| |ii||1
Nearside Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt |6.1.7 |g| |ii||1
Offside Rear Shock absorber has a serious fluid leak |2.7.3|1
Offside Front position lamp|s| not working |1.1.A.3b|1
Front coil spring broken |2.4.C.1a|1
Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e|1
Nearside Front coil spring fractured |2.4.C.1a|1
Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a|1
Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))1
Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))1
Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))1
Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill....... (6.1.1 (c) (i))1
Nearside Front Lower Suspension component ball joint excessively worn (5.3.4 (a) (i))1
Offside Parking brake inoperative on one side (1.4.1 (a))1
Parking brake efficiency below requirements (1.4.2 (a) (i))1

We get to these numbers by trawling through over 1 billion MOT test results since 2004 and crunched the numbers. We remove anything to do with Tyres, as they are model independent and group together common non-model specific issues. We are trying to get to a picture of what models have what issues.

Please note: We take the data from the DVSA. This data is raw and can contain typos and spelling mistakes that garages may have entered while recording a MOT result. Specifically miss-match on names of models and makes. We are constantly cleaning the data so bear with the odd issue.

Got suggestions? We’re improving this section all the time. If you have any suggestions, please let us know.

Find us on Facebook

© KnowYourCar™ 2019. All rights reserved
Except where otherwise noted, content on our MOT statistics pages are licensed under a Creative Commons Attribution 4.0 International license.
You are free to redistribute the material in any medium or format as long as credit is given to KnowYourCar

WARNING: We have placed hidden watermarks in our data. We will take action against our data being used outside of these terms.

MOT Data licensed under the Open Government Licence v3.0

By using our site you are agreeing to our terms and conditions
Terms & Conditions  Privacy Policy