| Most common failures | No# failures |
|---|
| Headlamp aim out of alignment | 12 |
| Offside Stop lamp not working |1.2.1b| | 5 |
| Windscreen wiper does not clear the windscreen effectively | 5 |
| Service brake efficiency below requirements (1.2.2 (a) (i)) | 5 |
| Rear brake binding | 4 |
| Brakes imbalanced across an axle | 3 |
| Rear parking brake recording little or no effort | 2 |
| Nearside Stop lamp not working |1.2.1b| | 2 |
| Centre Stop lamp not working |1.2.1b| | 2 |
| Registration plate issues | 2 |
| Nearside Rear position lamp|s| not working |1.1.A.3b| | 2 |
| Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt |6.1.7 |g| |ii|| | 2 |
| Battery insecure and likely to cause a short circuit |4.13 |a| |ii|| | 2 |
| Brake pipe excessively corroded | 2 |
| Registration plate lamp issues | 2 |
| Fuel tank leaking (7.2.3) | 2 |
| Nearside Front wheel bearing rough when rotated (2.5.A.2) | 2 |
| Parking brake efficiency below requirements (1.4.2 (a) (i)) | 2 |
| Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 2 |
| Emissions unable to be completed (8.2.2.2 (e)) | 2 |
| Windscreen washer not working | 2 |
| Offside Stop lamp not working (1.2.1b) | 2 |
| Parking brake: efficiency below requirements |3.7.B.7| | 1 |
| Nearside Upper Rear position lamp|s| not working |1.1.A.3b| | 1 |
| Offside Upper Rear position lamp|s| not working |1.1.A.3b| | 1 |
| Exhaust system not adequately supported |7.1.1| | 1 |
| Rear fog lamp not working |1.3.2b| | 1 |
| Nearside Front Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
| Nearside Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
| Nearside Obligatory mirror seriously damaged, affecting the rear view |8.1.2a| | 1 |
| Offside Headlamp insecure |1.7.3| | 1 |
| Offside Stop lamp adversely affected by the operation of another lamp |1.2.1f| | 1 |
| Rear Exhaust system not adequately supported |7.1.1| | 1 |
| Nearside Rear Upper Rear position lamp|s| not working |1.1.A.3b| | 1 |
| Nearside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
| Service brake: efficiency below requirements |3.7.B.7| | 1 |
| Nearside Front Direction indicator incorrect colour |4.4.3 |a|| | 1 |
| Offside Front Direction indicator incorrect colour |4.4.3 |a|| | 1 |
| Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength |5.3.6 |a| |i|| | 1 |
| Nearside Rear Inner Suspension component mounting prescribed area is excessively corroded sill |2.4.A.3| | 1 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded jack point |2.4.A.3| | 1 |
| Nearside Front Upper Suspension component mounting prescribed area is excessively corroded inner arch |2.4.A.3| | 1 |
| Nearside Front Inner Suspension component mounting prescribed area is excessively corroded flitch |2.4.A.3| | 1 |
| Offside Rear Inner Suspension component mounting prescribed area is excessively corroded sill |2.4.A.3| | 1 |
| Offside Front Inner Suspension component mounting prescribed area is excessively corroded flitch |2.4.A.3| | 1 |
| Offside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Offside Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
| Nearside Stop lamp(s) adversely affected by the operation of another lamp (4.3.3 (b)) | 1 |
| Brake load sensing valve seized but ABS functioning (1.1.17 (c) (i)) | 1 |
| Offside Front Side repeater insecure (1.4.A.2b) | 1 |
| Nearside Rear Stop lamp not working (1.2.1b) | 1 |
| Nearside Front Front wheel bearing rough when rotated (2.5.A.2) | 1 |
| Front Exhaust has part of the system excessively deteriorated (7.1.1a) | 1 |
| Offside front brake binding (3.7.B.1) | 1 |
| Fuel cap/sealing device ineffective temporary fuel cap fitted. (6.1.3 (b) (i)) | 1 |
| Power steering pipe/hose excessively corroded ALL pipes found at steering rack (2.1.5 (g) (i)) | 1 |
| Rear Brake cable damaged Handbrake cable (1.1.15 (a)) | 1 |
| Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Inner arch holed (6.1.1 (c) (i)) | 1 |
| Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Inner arch holed (6.1.1 (c) (i)) | 1 |
| Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
| Offside Front Upper Outline marker lamp not working (4.2.1 (a) (ii)) | 1 |
| Nearside Front Headlamp aim not tested dip beam not working (4.1.2 (b)) | 1 |
| Exhaust has a major leak of exhaust gases Front pipe corroded (6.1.2 (a)) | 1 |
| Nearside Front Direction indicator excessively deteriorated so that it is not visible from a reasonable distance (1.4.A.2e) | 1 |
| Offside Front Direction indicator excessively deteriorated so that it is not visible from a reasonable distance (1.4.A.2e) | 1 |
| Exhaust has a major leak of exhaust gases (7.1.2) | 1 |
| Nearside Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
| Central Upper Stop lamp(s) with a multiple light source more than 1/2 not functioning (4.3.1 (a) (ii)) | 1 |
| Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wing (5.3.6 (a) (i)) | 1 |
| Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
| Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i)) | 1 |
| All position lamps not working with key removed (4.2.1 (a)) | 1 |
| Offside Front wheel bearing rough when rotated (2.5.A.2) | 1 |
| Offside Rear Direction indicator incorrect colour (4.4.3 (a)) | 1 |
| Exhaust system insecure multiple mounting rubbers perished (6.1.2 (a)) | 1 |
| Exhaust emissions exceed manufacturers specified limit (8.2.2.2 (a)) | 1 |
| Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i)) | 1 |
| Offside Direction indicator incorrect colour front and rear (4.4.3 (a)) | 1 |
| Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced wheel arch/jacking point (6.1.1 (c) (i)) | 1 |
| Offside Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
| Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i)) | 1 |
| Offside Front Obligatory mirror insecure (3.3 (b) (ii)) | 1 |
| Offside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |
| Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 1 |
| Nearside Front Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Turret (5.3.6 (a) (i)) | 1 |
| Battery insecure and likely to fall from carrier (4.13 (a) (ii)) | 1 |
| Brake hose excessively deteriorated | 1 |
| Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced CRO0SSMEMBER (6.1.1 (c) (i)) | 1 |
| Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced JACKING POINT (6.1.1 (c) (i)) | 1 |
| Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i)) | 1 |
| Nearside Rear Service brake excessively binding (1.2.1 (f)) | 1 |
| Front Exhaust has a major leak of exhaust gases pipe broken (6.1.2 (a)) | 1 |
| Emissions not tested (8.2.2.2 (e)) | 1 |
| Nearside Upper Front position lamp(s) has less than 50% of the light sources illuminating (1.1.A.3b) | 1 |
| Offside Front Upper Front position lamp(s) not working (1.1.A.3b) | 1 |
| Offside Front Headlamp insecure (1.7.3) | 1 |
| Nearside Rear rear brake recording little or no effort (3.7.B.5a) | 1 |
| Rear brake application uneven | 1 |
| Nearside Front Service brake lagging in operation (1.2.1 (d)) | 1 |
| Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Subframe Mount (5.3.6 (a) (i)) | 1 |
| Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Subframe Mount (5.3.6 (a) (i)) | 1 |
| Nearside Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a)) | 1 |
| Offside Rear Upper Outline marker lamp not working (4.2.1 (a) (ii)) | 1 |
| Nearside Windscreen wiper not operating automatically when switched on (8.2.1b) | 1 |
| Offside Windscreen wiper not operating automatically when switched on (8.2.1b) | 1 |
| Nearside Rear position lamp(s) not working (1.1.A.3b) | 1 |
| Offside Front All position lamps not working (1.1.A.3b) | 1 |
| Nearside Stop lamp not working (1.2.1b) | 1 |
| Centre Stop lamp not working (1.2.1b) | 1 |
| Brake load sensing valve seized (3.6.E.3) | 1 |
| Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i)) | 1 |
| Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
| Exhaust has a major leak of exhaust gases Centre pipe (6.1.2 (a)) | 1 |
| Oil leaking excessively from engine (8.4.1 (a) (i)) | 1 |
| Offside Front Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i)) | 1 |
| Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 1 |
| Offside Rear Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |