| Most common failures | No# failures |
|---|
| Parking brake: efficiency below requirements |3.7.B.7| | 3 |
| Front Headlamp not working on main beam |1.7.5a| | 2 |
| Rear Stop lamp not working |1.2.1b| | 1 |
| Front Windscreen wiper not operating automatically when switched on |8.2.1b| | 1 |
| Front Braking system leaking |3.6.A.1| | 1 |
| Brake hydraulic reservoir fluid level below minimum level |3.6.G.1b| | 1 |
| Offside Front Upper Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
| Nearside Front Upper Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
| Rear reflector missing |1.5.1a| | 1 |
| Service brake: efficiency below requirements |3.7.B.7| | 1 |
| Nearside Headlamp aim projected beam image is obviously incorrect |4.1.2 |c|| | 1 |
| Offside Rear Suspension spring mounting prescribed area is excessively corroded wheel arch |2.4.A.3| | 1 |
| Offside Front Suspension component mounting prescribed area is excessively corroded outer sill |2.4.A.3| | 1 |
| Offside Front Suspension component mounting prescribed area is excessively corroded inner sill |2.4.A.3| | 1 |
| Headlamp switch faulty |1.7.1| | 1 |
| Rear Exhaust system not adequately supported |7.1.1| | 1 |
| Exhaust emissions hydrocarbon content excessive |7.3.B.1b| | 1 |
| Exhaust emits dense blue smoke at idle |7.3.A.2b| | 1 |
| Exhaust emits excessive dense blue smoke during acceleration |7.3.A.2c| | 1 |
| Nearside Rear Fuel pipe leaking |7.2.3| | 1 |
| Nearside Front Upper Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Offside Front Upper Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Parking brake lever has no reserve travel |3.1.6b| | 1 |
| Headlamp not working on dipped beam |1.7.5a| | 1 |
| Headlamp not working on main beam |1.7.5a| | 1 |
| Exhaust has a major leak of exhaust gases |6.1.2 |a|| | 1 |
| Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 1 |
| Nearside Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
| Offside Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
| Nearside Front Upper Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Offside Front Upper Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Headlamp aim out of alignment | 1 |
| Fuel system component leaking |7.2.3| | 1 |
| Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Steering system excessively tight |2.2.D.1| | 1 |
| Steering system excessively rough |2.2.D.1| | 1 |
| Offside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |