Most common failures | No# failures |
---|
Registration plate lamp issues | 2 |
Brake pipe excessively corroded | 2 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Offside Front Track rod end ball joint has excessive play |2.2.B.1f| | 2 |
Rear Rear fog lamp not working |1.3.2b| | 1 |
Offside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front Front wheel bearing has excessive play |2.5.A.3c| | 1 |
Horn not working |1.6.2a| | 1 |
Nearside Rear rear brake recording little or no effort |3.7.B.5a| | 1 |
Parking brake: efficiency below requirements |3.7.B.7| | 1 |
Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Side repeater not working |1.4.A.2c| | 1 |
Hazard warning switch faulty |1.4.B.1d| | 1 |
Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f| | 1 |
Offside Rear Rear wheel bearing rough when rotated |2.6.1| | 1 |
Nearside Outer Front Lower Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Nearside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Outer Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Inner Rear Lower Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front Macpherson strut upper support bearing is stiff in operation |2.5.B.1b| | 1 |
Centre Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |