| Most common failures | No# failures |
|---|
| Headlamp aim out of alignment | 3 |
| Registration plate lamp issues | 2 |
| Rear fog lamp not working (4.5.1 (a) (ii)) | 2 |
| Offside Headlamp insecure (4.1.1 (c)) | 2 |
| Nearside Front Macpherson strut ball joint excessively worn (5.3.4 (a) (i)) | 1 |
| Offside Front Macpherson strut ball joint excessively worn (5.3.4 (a) (i)) | 1 |
| Emissions not tested (8.2.2.2 (e)) | 1 |
| Nearside Front Anti-roll bar ball joint excessively worn (5.3.4 (a) (i)) | 1 |
| Offside Front Anti-roll bar ball joint excessively worn (5.3.4 (a) (i)) | 1 |
| Nearside Front Front constant velocity joint is insecure |2.5.C.1b| | 1 |
| Offside Front Front constant velocity joint is insecure |2.5.C.1b| | 1 |
| Offside Stop lamp not working |1.2.1b| | 1 |
| Offside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Nearside Front Headlamp aim aimed so that it dazzles other road users |1.8.A.1a| | 1 |
| Centre Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Nearside Inner Exhaust system not adequately supported |7.1.1| | 1 |
| Rear parking brake recording little or no effort | 1 |
| Parking brake: efficiency below requirements |3.7.B.7| | 1 |
| Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
| Offside Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength middle (5.3.6 (a) (i)) | 1 |
| Offside Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Middle to front (5.3.6 (a) (i)) | 1 |
| Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
| Headlamp levelling device inoperative (4.1.5 (a)) | 1 |
| Emissions unable to be completed (8.2.2.2 (e)) | 1 |
| Windscreen wiper does not clear the windscreen effectively | 1 |
| Windscreen washer not working | 1 |