Most common failures | No# failures |
---|
Brake pipe excessively corroded | 4 |
Windscreen wiper does not clear the windscreen effectively | 3 |
Exhaust emissions carbon monoxide content at idle excessive |7.3.D.4| | 3 |
Rear parking brake recording little or no effort | 1 |
Power steering pipe|s| or hose|s| leaking |2.3.3b| | 1 |
Offside Front suspension has excessive play in a upper suspension ball joint |2.5.B.1a| | 1 |
Offside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
Nearside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
Parking brake: efficiency below requirements |3.7.B.7| | 1 |
Nearside Front Side repeater not working |1.4.A.2c| | 1 |
Offside Rear fog lamp not working |1.3.2b| | 1 |
Offside Front Upper Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
Offside Front Lower Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
Offside Windscreen wiper not operating over a large enough area to give an adequate view |8.2.1c| | 1 |
Battery insecure |1.9.1| | 1 |
Exhaust emissions Lambda reading after 2nd fast idle outside specified limits |7.3.D.3| | 1 |
Offside Obligatory mirror seriously damaged, affecting the rear view |8.1.2a| | 1 |
Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Rear brake application uneven | 1 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
Nearside Headlamp excessively damaged so that the light output is severely reduced |1.7.5a| | 1 |
Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 1 |
Exhaust has a part missing |7.1.1a| | 1 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Rear Stop lamp not working |1.2.1b| | 1 |
Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |