Most common failures | No# failures |
---|
Registration plate lamp issues | 8 |
Windscreen wiper does not clear the windscreen effectively | 5 |
Nearside Stop lamp not working |1.2.1b| | 4 |
Rear brake binding | 4 |
Offside Front Suspension arm has excessive play in a ball joint |2.4.G.2| | 3 |
Headlamp aim out of alignment | 3 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 3 |
Brake pipe excessively corroded | 3 |
Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 3 |
Parking brake lever has no reserve travel |3.1.6b| | 2 |
Nearside Front Suspension arm has excessive play in a ball joint |2.4.G.2| | 2 |
Exhaust emissions carbon monoxide content at idle excessive |7.3.D.4| | 2 |
Front brake disc in such a condition that it is seriously weakened | 2 |
Offside Front position lamp|s| not working |1.1.A.3b| | 2 |
Parking brake: efficiency below requirements |3.7.B.7| | 2 |
Nearside Front Lower Suspension arm ball joint excessively worn |5.3.4 |a| |i|| | 1 |
Offside Front Anti-roll bar linkage ball joint excessively worn |5.3.4 |a| |i|| | 1 |
Nearside Front Anti-roll bar linkage has excessive play in a ball joint |2.4.G.2| | 1 |
Offside Stop lamp not working |1.2.1b| | 1 |
Engine MIL inoperative or indicates a malfunction |8.2.1.2 |h|| | 1 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill holed |5.3.6 |a| |i|| | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill holed x 2. |5.3.6 |a| |i|| | 1 |
Offside Front Macpherson strut pin or bush excessively worn upper mount top excess play. |5.3.4 |a| |i|| | 1 |
Nearside Front Lower Suspension arm rubber bush bonding deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Offside Front Inner Suspension component mounting prescribed area is inadequately repaired wing (5.3.6 (a) (i)) | 1 |
Fuel hose leaking |7.2.3| | 1 |
Nearside Front Lower Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill |5.3.6 |a| |i|| | 1 |
Nearside Stop lamp|s| not working |4.3.1 |a| |ii|| | 1 |
Nearside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
Nearside Front front brake binding |3.7.B.1| | 1 |
Bonnet cannot be secured in the closed position |8.4.1| | 1 |
Nearside Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Access panel cannot be secured in the closed position bonnet |6.4.1| | 1 |
Offside Front Front suspension has excessive movement at a wishbone pin or bush wishbone rear bush |2.5.A.1c| | 1 |
Nearside Front Macpherson strut has excessive movement at the upper attachment |2.5.A.1c| | 1 |
Offside Front Macpherson strut has excessive movement at the upper attachment |2.5.A.1c| | 1 |
Nearside Front Seat belt anchorage prescribed area is excessively corroded outer sill area |5.2.6| | 1 |
Nearside front brake binding |3.7.B.1| | 1 |
Front brake application uneven | 1 |
Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced Outer sill |7.1.1 |a| |i|| | 1 |
Nearside front brakes release unevenly |3.7.B.4| | 1 |
Rear parking brake recording little or no effort | 1 |
Rear brake application uneven | 1 |
Nearside Front Front position lamp|s| not working |1.1.A.3b| | 1 |