| Most common failures | No# failures |
|---|
| Registration plate issues | 7 |
| Rear brake application uneven | 2 |
| Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b)) | 2 |
| Windscreen wiper does not clear the windscreen effectively | 2 |
| Headlamp aim out of alignment | 2 |
| Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b)) | 2 |
| Offside Stop lamp not working |1.2.1b| | 2 |
| Parking brake: efficiency below requirements |3.7.B.7| | 2 |
| Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 2 |
| Parking brake efficiency below requirements (1.4.2 (a) (i)) | 2 |
| Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e| | 1 |
| Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
| Offside Rear Rear position lamp|s| not working |1.1.A.3b| | 1 |
| Rear fog lamp not working |1.3.2b| | 1 |
| Nearside Front Anti-roll bar has excessive play in a pin/bush |2.4.G.2| | 1 |
| Offside Front Anti-roll bar has excessive play in a pin/bearing |2.4.G.2| | 1 |
| Offside Rear fog lamp not working |1.3.2b| | 1 |
| Rear fog lamp switch faulty |1.3.1a| | 1 |
| Horn not working |1.6.2a| | 1 |
| Rear brake binding | 1 |
| Offside Rear Exhaust system not adequately supported |7.1.1| | 1 |
| Power steering pump leaking from a failed component |2.3.3b| | 1 |
| Nearside Outer Front Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Offside Outer Front Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Rear parking brake recording little or no effort | 1 |
| Windscreen washer not working | 1 |
| Nearside Brake hose leaking |3.6.A.1| | 1 |
| Offside Side repeater not working (4.4.1 (a) (ii)) | 1 |
| Nearside Headlamp not working on main beam (4.1.1 (a) (ii)) | 1 |
| Offside Headlamp not working on main beam |1.7.5a| | 1 |
| Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone `A` |8.3.1b| | 1 |
| Exhaust emissions - engine idle speed too high (8.2.1.2 (e)) | 1 |
| Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c)) | 1 |
| Exhaust carbon monoxide content at idle exceeds manufacturers specified limits (8.2.1.2 (b)) | 1 |
| Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (8.1.1 (a)) | 1 |
| Stop lamp(s) all not working (4.3.1 (a) (iii)) | 1 |
| Battery insecure |1.9.1| | 1 |
| Nearside Stop lamp not working |1.2.1b| | 1 |
| Nearside Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Exhaust emissions Lambda reading after 2nd fast idle outside specified limits |7.3.D.3| | 1 |
| Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 1 |
| Front Drag link end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
| Hazard warning switch missing |1.4.B.1d| | 1 |
| Brake hose excessively deteriorated | 1 |
| Nearside Rear Stop lamp not working |1.2.1b| | 1 |
| Nearside Front Headlamp not working on dipped beam |4.1.1 |a| |ii|| | 1 |
| Offside Front Headlamp not working on dipped beam |4.1.1 |a| |ii|| | 1 |
| Registration plate lamp issues | 1 |
| Nearside Lower Ball joint has excessive play |2.2.B.1f| | 1 |
| Offside Front Torque/reaction arm rubber bush bonding deteriorated resulting in excessive movement |2.4.G.2| | 1 |