Most common failures | No# failures |
---|
Brake pedal spongy |3.3.B.1b| | 2 |
Nearside Rear Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 2 |
Offside Rear Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 2 |
Brakes imbalanced across an axle | 2 |
Nearside rear brake recording little or no effort |3.7.B.5a| | 2 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
Headlamp aim out of alignment | 1 |
Nearside Headlamp aim not tested |1.8.A.1c| | 1 |
Rear brake application uneven | 1 |
Nearside Rear Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Nearside Front Headlamp not working on main beam (4.1.1 (a) (ii)) | 1 |
Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i)) | 1 |
Nearside Front Anti-roll bar linkage insecure and impairing directional stability (5.3.3 (a) (ii)) | 1 |
Offside Front Anti-roll bar linkage insecure and impairing directional stability (5.3.3 (a) (ii)) | 1 |
Windscreen washer not working | 1 |
Offside Front Drag link end ball joint has excessive play (2.1.3 (b) (i)) | 1 |
Offside Front Headlamp not working on main beam (4.1.1 (a) (ii)) | 1 |
Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Brake pedal has insufficient reserve movement |3.3.A.5| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front Braking system leaking |3.6.A.1| | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Front Shock absorber has a serious fluid leak |2.7.3| | 1 |
Nearside Front Front suspension ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Offside Front Front suspension ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Nearside Seat belt anchorage prescribed area is excessively corroded outer sill |5.2.6| | 1 |
Nearside Seat belt anchorage prescribed area is excessively corroded front floor |5.2.6| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded inner wing |2.4.A.3| | 1 |
Brake hose excessively deteriorated | 1 |
Rear Exhaust system not adequately supported |7.1.1| | 1 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 1 |
Parking brake lever has no reserve travel |3.1.6b| | 1 |
Brake pipe excessively corroded | 1 |
Brake pedal anti-slip provision incomplete |3.3.A.1b| | 1 |
Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e| | 1 |
Offside Rear wheel cylinder leaking |3.6.A.1| | 1 |
Emissions not tested |7.0| | 1 |
Nearside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Nearside Front Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
Offside Front Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
Offside Rear Subframe mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
Offside Front Anti-roll bar linkage has excessive play in a pin/bush |2.4.G.2| | 1 |