| Most common failures | No# failures |
|---|
| Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 5 |
| Service brake: efficiency below requirements |3.7.B.7| | 5 |
| Headlamp aim out of alignment | 3 |
| Exhaust emissions hydrocarbon content excessive |7.3.B.1b| | 3 |
| Parking brake lever has no reserve travel |3.1.6b| | 3 |
| Parking brake: efficiency below requirements |3.7.B.7| | 3 |
| Registration plate lamp issues | 3 |
| Offside rear brake recording little or no effort |3.7.B.5a| | 2 |
| Nearside rear brake recording little or no effort |3.7.B.5a| | 2 |
| Brake hydraulic reservoir fluid level below minimum level |3.6.G.1b| | 2 |
| Nearside Front front brake binding |3.7.B.1| | 2 |
| Offside Front front brake binding |3.7.B.1| | 2 |
| Rear parking brake recording little or no effort | 2 |
| Brake hose excessively deteriorated | 2 |
| Offside Rear Upper Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Nearside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Offside Front Anti-roll bar ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Brake pedal has insufficient reserve movement |3.3.A.5| | 1 |
| Nearside Front Seat belt insecurely fixed to the vehicles structure |5.2.1a| | 1 |
| Front passenger door cannot be opened from outside the vehicle |6.2.B.1b| | 1 |
| Offside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Nearside Front Seat belt buckle not functioning as intended (7.1.2 (d)) | 1 |
| Offside Front Seat belt buckle not functioning as intended (7.1.2 (d)) | 1 |
| Windscreen washer not working | 1 |
| Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b)) | 1 |
| Offside Rear Stop lamp not working |1.2.1b| | 1 |
| Brake hose has insufficient room to move | 1 |
| Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Windscreen wiper does not clear the windscreen effectively | 1 |
| Brake pedal creeps down when held under pressure |3.3.B.1a| | 1 |
| Offside Front Shock absorber has a serious fluid leak |2.7.3| | 1 |
| Offside Front Lower Shock absorber has an excessively worn bush |2.7.4| | 1 |
| Offside Front Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
| Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Nearside Front Headlamp not working on main beam |1.7.5a| | 1 |
| Horn not working |1.6.2a| | 1 |
| Nearside Headlamp aim beam image kick up to the offside |1.8| | 1 |
| Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Offside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Nearside Rear Braking system leaking caliper area |3.6.A.1| | 1 |
| Brake fluid warning lamp illuminated |3.6.G.2| | 1 |
| Brakes imbalanced across an axle | 1 |
| Brake pedal spongy |3.3.B.1b| | 1 |
| Brake pedal creeps down while the pedal is held under pressure |3.3.B.1a| | 1 |
| Exhaust emits excessive dense blue smoke during acceleration |7.3.A.2c| | 1 |
| Nearside Rear Lower Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Rear Lower Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Parking brake: efficiency below requirements |3.7.C.1b| | 1 |
| Nearside Front Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Offside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
| Nearside Headlamp not working on main beam |1.7.5a| | 1 |
| Nearside Front Side repeater not working |1.4.A.2c| | 1 |
| Front Exhaust system not adequately supported |7.1.1| | 1 |
| Nearside Front Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
| Offside Front Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
| Offside Headlamp aim beam image kick up to the offside |1.8| | 1 |
| Nearside front brake binding |3.7.B.1| | 1 |
| Offside front brake binding |3.7.B.1| | 1 |
| Offside Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
| Nearside Rear Upper Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Brake pipe excessively corroded | 1 |
| Rear brake binding | 1 |
| Nearside Front Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
| Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Nearside Rear Service brake excessively binding (1.2.1 (f)) | 1 |