| Most common failures | No# failures |
|---|
| Registration plate lamp issues | 4 |
| Nearside Steering rack gaiter split |2.2.D.2d| | 2 |
| Exhaust emissions Lambda reading after 2nd fast idle outside specified limits |7.3.D.3| | 2 |
| Nearside Front Side repeater not working |4.4.1 |a| |ii|| | 2 |
| Offside Front Engine mounting bracket damaged or deteriorated resulting in excessive movement (6.1.8 (a) (i)) | 1 |
| Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
| Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
| Offside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |
| Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) | 1 |
| Nearside Rear Suspension component mounting prescribed area is inadequately repaired (5.3.6 (a) (i)) | 1 |
| Offside Rear Suspension arm pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Central Rear Brake load sensing valve inoperative and ABS not fitted or inoperative (1.1.17 (c) (ii)) | 1 |
| Emissions not tested NO READING DUE TO VERY LITTLE BACK PRESSURE (8.2.1.2 (d)) | 1 |
| Driver`s door cannot be opened from inside the vehicle |6.2.B.1b| | 1 |
| Nearside Side repeater not working |1.4.A.2c| | 1 |
| Offside Side repeater not working |1.4.A.2c| | 1 |
| Rear Exhaust system not adequately supported |7.1.1| | 1 |
| Offside Steering rack gaiter split |2.2.D.2d| | 1 |
| Offside Front Anti-roll bar linkage worn and seriously weakened |2.4.G.1| | 1 |
| Brake load sensing valve linkage obviously incorrectly adjusted |3.6.E.3| | 1 |
| Service brake: efficiency below requirements |3.7.B.7| | 1 |
| Offside Rear Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Exhaust system not adequately supported |7.1.1| | 1 |
| Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
| Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
| Offside Front passenger door cannot be opened from inside the vehicle |6.2.B.1b| | 1 |
| Nearside Front Anti-roll bar has excessive play in a pin/bush |2.4.G.2| | 1 |
| Fuel cap/sealing device ineffective unable to open fuel flap |6.1.3 |b| |i|| | 1 |
| Offside Rear fog lamp not working |4.5.1 |a| |ii|| | 1 |
| Offside Front Engine mounting damaged or deteriorated resulting in excessive movement TOP AND BOTTOM SIDE OF SUB FRAME ENGINE IN DANGER OF DROPPING (6.1.8 (a) (i)) | 1 |
| Exhaust carbon monoxide content after 2nd fast idle exceeds default limits |8.2.1.2 |b|| | 1 |
| Offside Rear Rear fog lamp not working |4.5.1 |a| |ii|| | 1 |
| Exhaust has a major leak of exhaust gases front pipe |6.1.2 |a|| | 1 |
| Exhaust has a major leak of exhaust gases middle silencer |6.1.2 |a|| | 1 |
| Nearside Rear Exhaust system insecure rubber come off bracket other bracket broken off and missing |6.1.2 |a|| | 1 |
| Offside Front Steering rack gaiter missing or no longer prevents the ingress of dirt |2.1.3 |g| |ii|| | 1 |
| Nearside Front Steering rack gaiter missing or no longer prevents the ingress of dirt |2.1.3 |g| |ii|| | 1 |
| Nearside Front Suspension arm pin or bush excessively worn inner front void bush |5.3.4 |a| |i|| | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing panel by lower arm |5.3.6 |a| |i|| | 1 |
| Offside Rear Brake hose porous |1.1.12 |e|| | 1 |
| Nearside Rear Brake hose porous |1.1.12 |e|| | 1 |
| Emissions not tested |8.2.1.2 |d|| | 1 |
| Nearside Stop lamp not working |1.2.1b| | 1 |
| Headlamp excessively deteriorated so that the light output is severely reduced both |1.7.5a| | 1 |
| Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 1 |
| Suspension component mounting prescribed area is excessively corroded rear crossmember |2.4.A.3| | 1 |