Most common failures | No# failures |
---|
Headlamp aim out of alignment | 5 |
Parking brake: efficiency below requirements |3.7.B.7| | 4 |
Horn not working |1.6.2a| | 4 |
Service brake: efficiency below requirements |3.7.B.7| | 4 |
Brake pipe excessively corroded | 3 |
Brakes imbalanced across an axle | 3 |
Registration plate lamp issues | 3 |
Nearside Front Direction indicator not working |1.4.A.2c| | 2 |
Rear brake binding | 2 |
Offside Headlamp insecure |1.7.3| | 1 |
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Rear Lower Shock absorber has an excessively worn bush |2.7.4| | 1 |
Offside Stop lamp not working |1.2.1b| | 1 |
Offside Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Rear rear brake recording little or no effort nearside & offside |3.7.B.5a| | 1 |
Brake pedal spongy |3.3.B.1b| | 1 |
Brake pedal creeps down while the pedal is held under pressure |3.3.B.1a| | 1 |
Rear fog lamp adversely affected by the operation of another lamp fog light on constant with side lamps |1.3.2f| | 1 |
Offside Stop lamp emits other than a steady red light emitting white light due to lens deteriotion |1.2.1e| | 1 |
Front brake application uneven | 1 |
Rear brake application uneven | 1 |
Nearside Front Headlamp insecure |1.7.3| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded jackink point |2.4.A.3| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded inner wheel arch |2.4.A.3| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded jacking point |2.4.A.3| | 1 |
Nearside Front Brake hose twisted |3.6.B.4c| | 1 |
Central Exhaust silencer insecure |8.1.1 |b| |i|| | 1 |
Nearside Front Headlamp aim not tested |4.1.2 |b|| | 1 |
Nearside Front Headlamp lens seriously defective |4.1.1 |b| |ii|| | 1 |
Offside Front Side repeater not working |4.4.1 |a| |ii|| | 1 |
Nearside Front Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting foot step |6.2.2 |d| |i|| | 1 |
Offside Front Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting foot step |6.2.2 |d| |i|| | 1 |
Nearside Front Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting wing |6.2.2 |d| |i|| | 1 |
Offside Front Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting wing |6.2.2 |d| |i|| | 1 |
Service brake efficiency below requirements |1.2.2 |a| |i|| | 1 |
Parking brake efficiency below requirements |1.4.2 |a| |i|| | 1 |
Nearside Front Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Offside Front Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Rear Parking brake lever has no reserve travel |3.1.6b| | 1 |
Rear Mechanical brake component has restricted free movement | 1 |
Nearside Rear Service brake excessively binding |1.2.1 |f|| | 1 |
Brake hose excessively deteriorated | 1 |
Offside Rear Shock absorbers has an excessively worn bush |5.3.2 |c|| | 1 |
Nearside Front Suspension arm pin or bush excessively worn marked in yellow |5.3.4 |a| |i|| | 1 |
Offside Front Suspension arm pin or bush excessively worn marked in yellow |5.3.4 |a| |i|| | 1 |
Emissions not tested excess smoke |8.2.2.2 |e|| | 1 |
Nearside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Offside Rear Rear position lamp|s| not working |1.1.A.3b| | 1 |
Offside Front Stop lamp not working |1.2.1b| | 1 |