Most common failures | No# failures |
---|
Headlamp aim out of alignment | 7 |
Registration plate lamp issues | 5 |
Exhaust has a major leak of exhaust gases |7.1.2| | 3 |
Exhaust system not adequately supported |7.1.1| | 3 |
Battery insecure |1.9.1| | 3 |
Windscreen wiper does not clear the windscreen effectively | 3 |
Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement |7.2.4b| | 3 |
Registration plate issues | 3 |
Offside Headlamp excessively damaged so that the light output is severely reduced |1.7.5a| | 2 |
Offside Headlamp insecure |1.7.3| | 2 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 2 |
Offside Stop lamp not working |1.2.1b| | 2 |
Nearside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 2 |
Offside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 2 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Rear brake binding | 2 |
Offside Headlamp not working on dipped beam |1.7.5a| | 2 |
Nearside Headlamp insecure |1.7.3| | 2 |
Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Offside Rear wheel bearing rough when rotated |2.6.1| | 1 |
Front Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |
Offside wheel cylinder leaking |3.6.A.1| | 1 |
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
Nearside Front Brake prescribed area is excessively corroded (1.1.21 (e) (i)) | 1 |
Offside Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
Offside Front Direction indicator not working (4.4.1 (a) (ii)) | 1 |
Battery insecure and likely to fall from carrier (4.13 (a) (ii)) | 1 |
Nearside Rear Service brake excessively binding (1.2.1 (f)) | 1 |
Offside Front Drivers door does not latch securely closed (6.2.3 (a)) | 1 |
Rear Exhaust mounting missing |7.1.1b| | 1 |
Nearside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Offside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Nearside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
Windscreen wiper not operating automatically when switched on |8.2.1b| | 1 |
Front Exhaust system not adequately supported |7.1.1| | 1 |
Front passenger door cannot be opened from outside the vehicle |6.2.B.1b| | 1 |
Horn not working |1.6.2a| | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Offside Rear fog lamp not working |1.3.2b| | 1 |
Hazard warning lamps inoperative |1.4.B.1b| | 1 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Front position lamp|s| insecure |1.1.A.3a| | 1 |
Offside Front position lamp|s| insecure |1.1.A.3a| | 1 |
Nearside Rear position lamp|s| insecure |1.1.A.3a| | 1 |
Offside Rear position lamp|s| insecure |1.1.A.3a| | 1 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
Parking brake lever, pawl mechanism pivots or their associated mountings are insecure |3.1.4b| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Upper Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Front Windscreen wiper blade deteriorated |8.2.2| | 1 |
Parking brake: efficiency below requirements |3.7.C.1b| | 1 |
Brake load sensing valve has been disconnected and was fitted as standard |3.6.E.2| | 1 |
All position lamps adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Direction indicators adversely affected by the operation of another lamp |1.4.A.2h| | 1 |
Nearside Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
Offside Headlamp not working on main beam |1.7.5a| | 1 |
Offside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Centre Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |
brake disc excessively pitted |3.5.1h| | 1 |
Offside Brake pipe twisted |found during steering lock to lock check| |2.2.D.2b| | 1 |
Offside Front position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Offside Headlamp adversely affected by the operation of another lamp |1.7.5c| | 1 |
Offside Front Braking system leaking |3.6.A.1| | 1 |
Offside Headlamp aim not tested |1.8.A.1c| | 1 |
Nearside Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Offside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Front Lower Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Offside Front Lower Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Nearside Front Lower Seat belt anchorage prescribed area is inadequately repaired |5.2.6| | 1 |