| Most common failures | No# failures |
|---|
| Registration plate lamp issues | 4 |
| Headlamp aim out of alignment | 3 |
| Nearside Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 3 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
| Exhaust emissions Lambda reading after 2nd fast idle outside specified limits |7.3.D.3| | 3 |
| Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 2 |
| Windscreen wiper does not clear the windscreen effectively | 2 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded inner arch |2.4.A.3| | 1 |
| Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength jacking point (5.3.6 (a) (i)) | 1 |
| Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i)) | 1 |
| Central Fuel pipe insecure gas conversion pipe (6.1.3 (a) (i)) | 1 |
| Nearside Rear Direction indicator not working |1.4.A.2c| | 1 |
| Offside Rear fog lamp emits a light other than red |1.3.2e| | 1 |
| Brake pedal anti-slip provision incomplete |3.3.A.1b| | 1 |
| Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Nearside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Offside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Nearside Front suspension has a suspension lower ball joint securing nut not locked |2.5.B.1a| | 1 |
| Nearside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Fuel pipe leaking |7.2.3| | 1 |
| Nearside Rear Subframe mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
| Offside Rear Subframe mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
| Offside Rear Brake pipe inadequately supported |3.6.B.1| | 1 |
| Nearside Brake pipe inadequately supported |3.6.B.1| | 1 |
| Exhaust emissions carbon monoxide content at idle excessive |7.3.D.4| | 1 |
| Nearside Stop lamp not working |1.2.1b| | 1 |
| Nearside Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
| Nearside Rear Stub axle has excessive vertical movement between stub axle and axle beam |2.5.A.1a| | 1 |
| Offside Rear Stub axle has excessive vertical movement between stub axle and axle beam |2.5.A.1a| | 1 |
| Exhaust emissions hydrocarbon content after 2nd fast idle excessive |7.3.D.3| | 1 |
| Brake pipe excessively corroded | 1 |
| Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
| Offside Front Sub-frame corroded and seriously weakened |2.4.G.1| | 1 |
| Nearside Rear Coil spring fractured or broken |5.3.1 |b| |i|| | 1 |
| Offside Rear Coil spring fractured or broken |5.3.1 |b| |i|| | 1 |
| Brake pedal anti-slip provision missing |3.3.A.1b| | 1 |
| Front Exhaust system not adequately supported |7.1.1| | 1 |
| Brakes imbalanced across an axle | 1 |
| Nearside rear brake recording little or no effort |3.7.B.5a| | 1 |
| Rear brake application uneven | 1 |
| Offside Rear Fuel pipe leaking filler pipe |7.2.3| | 1 |
| Offside Rear fog lamp not working |1.3.2b| | 1 |
| Nearside Rear Braking system leaking brake pipe |3.6.A.1| | 1 |
| Nearside Front Lower Suspension arm has excessive play in a ball joint and boot damaged |2.4.G.2| | 1 |
| Offside Front Lower Suspension arm has excessive play in a ball joint and boot damaged |2.4.G.2| | 1 |
| Offside Rear Shock absorber has a serious fluid leak |2.7.3| | 1 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded sill back |2.4.A.3| | 1 |
| Offside Front Wheel nut|s| missing |4.2.A.1e| | 1 |
| Battery insecure |1.9.1| | 1 |