| Most common failures | No# failures |
|---|
| Rear parking brake recording little or no effort | 4 |
| Brakes imbalanced across an axle | 4 |
| Parking brake: efficiency below requirements |3.7.B.7| | 2 |
| Offside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 2 |
| Brake hose excessively deteriorated | 2 |
| Offside Front position lamp|s| not working |1.1.A.3b| | 2 |
| Oil leaking excessively from engine (8.4.1 (a) (i)) | 2 |
| Nearside Rear Direction indicator incorrect colour |1.4.A.2f| | 2 |
| Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
| Offside Front Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
| Offside Front Suspension arm locating pin insecure |2.4.G.3a| | 1 |
| Nearside Front Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected Inner wheel arch. (5.3.6 (a) (ii)) | 1 |
| Offside Front Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected Inner wheel arch. (5.3.6 (a) (ii)) | 1 |
| Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Nearside Rear Parking brake lever has no reserve travel Cable snapped |3.1.6b| | 1 |
| Nearside Side repeater not working |1.4.A.2c| | 1 |
| Offside Side repeater not working |1.4.A.2c| | 1 |
| Offside Front coil spring broken |2.4.C.1a| | 1 |
| Fuel hose insecure Filler neck hose clip loose (6.1.3 (a) (i)) | 1 |
| Rear Exhaust emissions likely to be affected by an induction leak (8.2.1.1 (b)) | 1 |
| Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Wheel arch (5.3.6 (a) (i)) | 1 |
| Centre Exhaust system not adequately supported |7.1.1| | 1 |
| Rear Exhaust has a major leak of exhaust gases silencer (6.1.2 (a)) | 1 |
| Rear Exhaust system insecure silencer (6.1.2 (a)) | 1 |
| Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
| Offside Front Direction indicator not working (4.4.1 (a) (ii)) | 1 |
| Offside front brake juddering severely |3.7.A.2b| | 1 |
| Nearside Front Seat belt anchorage prescribed area is excessively corroded sill |5.2.6| | 1 |
| Offside Front Subframe mounting prescribed area is excessively corroded inner wheel arch |2.4.A.3| | 1 |
| Engine MIL inoperative or indicates a malfunction |8.2.1.2 |h|| | 1 |
| Offside Windscreen wiper not working |3.4 |a|| | 1 |
| Steering component mounting prescribed area is fractured bulkhead behind brake servo |2.2.C.1h| | 1 |
| Offside Front Macpherson strut corroded and seriously weakened |2.4.G.1| | 1 |
| Offside Seat belt anchorage prescribed area is excessively corroded centre floor |5.2.6| | 1 |
| Registration plate lamp issues | 1 |
| Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
| Nearside Headlamps matched pair are not the same colour |1.7.6| | 1 |
| Nearside Seat belt anchorage prescribed area is excessively corroded centre floor |5.2.6| | 1 |
| Offside Rear Direction indicator incorrect colour |1.4.A.2f| | 1 |
| Nearside Rear Suspension component mounting prescribed area is excessively corroded inner arch |2.4.A.3| | 1 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded inner arch |2.4.A.3| | 1 |
| Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Emissions not tested |7.0| | 1 |