| Most common failures | No# failures |
|---|
| Parking brake: efficiency below requirements |3.7.B.7| | 5 |
| Registration plate lamp issues | 4 |
| Offside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 3 |
| Rear parking brake recording little or no effort | 3 |
| Nearside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 2 |
| Brake pipe excessively corroded | 2 |
| Headlamp aim out of alignment | 2 |
| Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 2 |
| Parking brake lever has no reserve travel |3.1.6b| | 2 |
| Offside Rear Stop lamp not working |1.2.1b| | 2 |
| Centre Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Rear Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 1 |
| Rear Exhaust emissions Lambda reading after 2nd fast idle outside specified limits |7.3.D.3| | 1 |
| Rear brake disc in such a condition that it is seriously weakened | 1 |
| Horn not working |1.6.2a| | 1 |
| Windscreen wiper does not clear the windscreen effectively | 1 |
| Nearside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
| Offside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
| Offside Rear Brake cable has wires broken and is significantly weakened |3.5.1b| | 1 |
| Nearside Headlamp insecure |1.7.3| | 1 |
| Nearside Front Lower Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
| Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
| Nearside Headlamp not working on main beam |1.7.5a| | 1 |
| Offside Front Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
| Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
| Offside Rear Rear fog lamp not working |1.3.2b| | 1 |
| Nearside Front Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
| Offside Rear fog lamp not working |1.3.2b| | 1 |
| Nearside Rear Body panel corroded and likely to cause injury wheel arch (6.2.1 (a) (i)) | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 1 |
| Offside Rear Body panel corroded and likely to cause injury wheel arch (6.2.1 (a) (i)) | 1 |
| Emissions not tested exhaust missing (8.2.1.2 (d)) | 1 |
| Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |